Chrysler-Dodge Radio Wire Harnesses - InstallDr

1 All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or vehicle Applications. The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting FromThe Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself.

2 Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death. Installs Are Taken At The Risk Of Each Installer, And/Or , Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohibited. Protected By Copyright Laws. 1997,1998,1999, Of VehiclesChrysler- dodge Radio wire HarnessesNote: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket Radio wire colors.

3 ** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle . This is anotherreason to use a snap on wire harness adapter. **AS VIEWED FROM MATING END OF CONNECTORABCDEFGHIJKLMNB lack PlugGray PlugTypical dodge /ChryslerTypical New RadioPinWhat It IsIn Dash wire ColorEquivalent wire ColorARight Rear Spkr (-)Blue w/ White StripePurple w/ Black StripeBLeft Rear Spkr (-)Brown w/ Yellow StripeGreen w/ Black StripeCRight Front Spkr (+)PurpleGrayDLeft Front Spkr (+)Dark GreenWhiteERight Rear Spkr (+)Blue w/ Orange StripePurpleFLeft Rear Spkr (+)Brown w/ Blue StripeGreenGPower Antenna/AmpWhite (use for Infinity Radio )

4 BlueH+12 Volt Battery WirePink or Pink w/ White StripeYellowI+12 Volt Ignition WireRed w/ White StripRedJRadio Dimmer WireDo Not UseKHeadlight Dimmer WireDo Not UseLRight Front Spkr (-)Blue w/ Red StripeGray w/ Black StripeMLeft Front Spkr (-)Brown w/ Red StripeWhite w/ Black StripeNNo WireMetal Braid Or Plastic Connector Attached To Back Of Radio Is The Ground WireBlack (see TIP)If your original Radio had a braided strap bolted to the rear of the your original Radio had a plastic connector containing a single wire plugged into the rear of the your original Radio or speaker grills were labeled or marked with INFINITY Crimp a ring terminal to the new radios ground wireand insert a bolt through both connectors to connectthe ring terminal of the braided ground wire to thering terminal attached to the new radios ground :Crimp a male tab spade to the new radiosground wire .

5 Slide it into the female tab spadeconnector that had originally snapped into therear of the factory :Crimp a male tab spade to the new radiosground wire . Slide it into the female tab spadeconnector that had originally snapped into therear of the factory Radio to ground the Infinityamp and activate the Infinity sound :All Information, Including Photos And Illustrations, In These Pages Is Believed To Be Correct And Reliable. The Information Contained In These Pages Is Given As General Information For The Installation Of Audio, Video, Security, Communications,And Other Accessory Products Into Mobile And/Or vehicle Applications.

6 The Install Doctor, Any Subsidiaries Or Divisions Thereof, Or Any Member Of These Companies Shall Not Be Held Liable For Any Damages And/Or Injuries Resulting FromThe Use Of Information Contained In These Pages. All Information Contained In These Pages Should Be Checked And Verified With Appropriate Test Equipment To Assure The Safety And Proper Operation Of Equipment Installed And The VehicleItself. Careful Attention Should Be Given To All Electronic/Electric Circuits. High Voltages And Currents Can Cause Bodily Injury, Skin Damage, And Even Death.

7 Installs Are Taken At The Risk Of Each Installer, And/Or , Duplication, or Retransmission Of This Document Not Expressly Authorized In Writing By The Install Doctor Is Prohibited. Protected By Copyright Laws. 1997,1998,1999, Joint Production VehiclesChrysler-Mitsubishi Radio wire HarnessesNote: using an optional snap on wire harness adapter will simplify the wiring. Most snap on wire harness adapters have already converted and color codedthe wires from the auto makers in dash wire harness to match typical aftermarket Radio wire colors.** The wire colors listed in the chart above are typical for these vehicles during these years but may not be the exact colors for this vehicle .

8 This is anotherreason to use a snap on wire harness adapter. **AS VIEWED FROM MATING END OF CONNECTORCDABHIFGEKJNMLM itsubishi- chrysler CorpTypical New RadioPinWhat It IsIn Dash wire ColorEquivalent wire ColorARight Front Speaker (+)Two White w/ Red StripeGrayBRight Rear Speaker (+)Yellow w/ Red StripePurpleCDo Not UseDLeft Front Speaker (+)Two White w/ Blue StripeWhiteELeft Rear Speaker (+)Yellow w/ Blue StripeGreenFLight Dimmer WireGHeadlight IlluminiationH+12 Volt Battery WireRed w/ Black StripeYellowI+12 Volt Ignition WireBlueRedJLeft Rear Speaker (-)Gray w/ Blue StripeGreen w/ Black StripeKRight Rear Speaker (-)

9 Gray w/ Red StripePurple w/ Black StripeLPower Antenna Turn OnBlueMLeft Front Speaker (-)Two Black w/ Blue StripeWhite w/ Black StripeNRight Front Speaker (-)Two Black w/ Black StripeGray w/ Black StripeNOTE: this vehicle does not have a (-) Ground wire attached to either connector. Theradio grounds when the metal brackets attached to the Radio screw into the metal dashor the ground wire from the new Radio is screwed into metal of the vehicles VIEWED FROM MATING END OF CONNECTORDEFGKLMABCHIJIf your original Radio had a metal female connector attached to a single wireplugged into the rear of the a male tab spade to the new radiosground wire .

10 Slide it into the female tab spadeconnector that had originally snapped into therear of the factory :Jeep- chrysler 1pc. Radio wire HarnessesTypical JeepTypical New RadioPinWhat It IsIn Dash wire ColorEquivalent wire ColorARight Rear Spkr (-)Blue w/ Orange StripePurple w/ Black StripeBRight Front Spkr (-)Blue w/ Red StripeGray w/ Black StripeCDo Not UseDRight Rear Spkr (+)Blue w/ White StripePurpleERight Front Spkr (+)PurpleGrayF+12 Volt Ignition WireLite Purple w/ White StripeRedG+12 Volt Battery WirePinkYellowHDo Not UseILeft Front Spkr (-)Brown w/ Red StripeWhite w/ Black StripeJLeft Rear Spkr (-)Brown w/ Blue StripeGreen w/ Black StripeKDo Not UseLLeft Front Spkr (+)GreenWhiteMLeft Rear Spkr (+)