RS-232/485/422 Serial Transceiver with Internal ...

500mA Low-Noise LDO Voltage Regulator

500mA Low-Noise LDO Voltage Regulator 500mA Low-Noise LDO Voltage Regulator August 2016 Rev. 2.0.3 Exar Corporation www.exar.com 48720 Kato Road, Fremont CA 94538, USA Tel. +1 510 668-7000 – Fax. +1 510 668-7001

  Noise, Voltage, Regulators, 500ma, 500ma low noise ldo voltage regulator, 500ma low noise ldo voltage regulator 500ma low noise ldo voltage regulator

SP5301 Universal Serial Bus Transceiver - Exar

Universal Serial Bus Transceiver ... Universal Bus. The USB is a cable bus that supports data exchange between a host computer and a wide range of peripherals.

  Serial, Universal, Universal serial bus, Universal bus

xr21V1414 130 12102013 - Exar

xr21v1414 3 rev. 1.3.0 4-ch full-speed usb uart note: tr = tape and reel, f = green / rohs figure 2. p in o ut a ssignment ordering information part n umber package operating t emperature r ange device s tatus xr21v1414im48-f 48-pin tqfp -40°c to +85°c active xr21v1414im48tr-f 48-pin tqfp -40°c to +85°c active

  Xr21v1414 130, Xr21v1414

SP481E SP485E DS - exar.com

Enhanced Low Power Half-Duplex RS-485 Transceivers SP1E SPE REV 1.0.5 1/9 FEATURES 5V only Low power BiCMOS Driver / receiver enable for multi-drop configurations Low power shutdown mode (SP481E) Enhanced ESD specifications: ±15kV Human Body Model

  Power, Enhanced, Half, Low power, Ep548s, Duplex, Sp481e sp485e, Sp481e, Enhanced low power half

SONET/SDH Essentials WHITE PAPER - Exar

WHITE PAPER 4 REV. 1.00 SONET/SDH ESSENTIALS 2.1 The STS-1 Framing Format The STS-1 frame forms the fundamental building block of the STS-N signals. The STS-1 frame structure is a matrix of 9 byte rows by 90 byte columns as illustrated below in

  Paper, Essential, White, Stones, Sonet sdh essentials white paper

XR-2209 - Exar

XR-2209 Rev. 2.02 5 PRECAUTIONS The following precautions should be observed when operating the XR-2209 family of integrated circuits: 1. Pulling excessive current from the timing terminals

  9202, Xr 2209

SP3222EB/SP3232EB True +3.0V to +5.5V RS-232 Transceivers

SP3222EB/SP3232EB True +3.0V to +5.5V RS-232 Transceivers The SP3222EB/SP3232EB series is an RS-232 transceiver solution intended for portable or

SP3243E 3 Driver/5 Receiver Intelligent +3.0V to +5.5V RS ...

Exar Corporation 48720 Kato Road, Fremont CA, 94538 • 510-668-7017 • www.exar.com SP3243E_102_060611 1 SP3243E 3 Driver/5 Receiver Intelligent +3.0V to +5.5V

  Intelligent, Receiver, Receiver intelligent 3, 0v to 5

RS-232 Mode Full Duplex RS-485 Mode Mode

RS-232/RS-485 Multi-Mode Serial Transceiver SP332 REV 1.0.1 1/11 FEATURES 5V only single supply operation Software programmable RS-232 orRS-485 line drivers and receivers. The configuration of the SP332 RS-485 selection 4 drivers, 4 receivers RS-232 2 drivers, 2 receivers RS-485 Loop back function for self test 28-pin WSOIC package

  Rs 232 rs 485

Wide Input Voltage Range, - Exar

Date: /20/06 SP7653 Wide Input Voltage Range, .3MHz, Buck Regulator © Copyright 2006 Sipex Corporation

  Ranges, Input, Voltage, Wide, Wide input voltage range

RS-232 to RS-485 Converter - Advantech

Model 485CON, RS-232 to RS-485 converter, converts unbalanced, full-duplex RS-232 signals to balanced, full-duplex or half-duplex RS-485 signals. RS-485 is an enhanced version of the RS-422 balanced line standard. It allows multiple drivers and receivers on a two-wire system.

Port Powered RS-232/485 Converters

When Switch 1 is in the RS-485 position, the RS-485 driver is automatically enabled during each spacing state on the RS-232 side. During the marking or idle state, the RS-485 …

RS-232 To RS-485 Interface Converter - ATEN

Systems based on the RS-485 standard, on the other hand, are not subject to the RS-232 limitations because they utilize different voltage lines for the data and control signals. The IC-485S / IC-485SI Converter is a bidirectional converter that transparently converts RS-232

RS-422 and RS-485 Application Note - Spread spectrum

An RS-232 to RS-485 converter can also be controlled by triggering from the data signal to enable the RS-485 driver. Figure 9 is a timing diagram of the important signals used to

  Notes, Applications, 422 and rs 485 application note

iCoupler® Digital Isolators Protect RS-232, RS-485, and ...

RS-232, RS-485, and CAN Buses in Industrial, Instrumentation, and Computer Applications By Scott Wayne [scott.wayne@analog.com] INTRODUCTION In applications such as industrial process control, power supply regulation, and point-to-point communications between

  Applications, Computer, Industrial, Instrumentation, Analog, Rs 485, Rs 232, And computer applications

RS-232/RS-485 serial data networking Description

RS-232/RS-485 serial data networking Description. The ELPRO 915U-D Wireless Serial Modem is an RS-232 or RS-485 data modem that enables cost effective, two-way communications between serial devices such as PLCs, RTUs, and other industrial . machinery to …

  Serial, Data, Descriptions, Networking, Rs 232 rs 485 serial data networking description

RS‑232/RS‑485 serial data networking Description

905U-D Wireless Serial Modem. RS‑232/RS‑485 serial data networking Description. The ELPRO 905U-D Wireless Serial Modem is a robust, license-free serial transceiver capable of long-range communications to

  Serial, Data, Descriptions, Networking, Rs 232 rs 485 serial data networking description

SE-485-DIN MANUAL OPTICALLY ISOLATED RS-232 TO RS …

The SE-485-DIN has terminal blocks on the RS-232 side and the RS-422-485 side. The RS-232 side also has a DB9 female connector. Transmit (TD), Receive (RD) and Ground are supported on the RS-232 side. The unit is powered by a supply voltage of 10 to 30 Vdc on the RS-232 side. Transmit Data A (-), Transmit Data B (+),

FX COMMUNICATION (RS-232C, RS-485, RS-422) USER S …

Foreword • This manual contains text, diagrams and explanations which will guide the reader in the correct installation and operation of the communication facilities of FX series.

  Communication, Rs 485, 232c, Fx communication, Rs 232c

RS-232/RS-485/RS-422 To Ethernet Converter RC33

RS-232/RS-485/RS-422 to Ethernet Converter RC33 is device for convert serial communication (RS232/RS485) to Ethernet without changing any software. RC33 is compatible with any software since it does not change protocol instead it using Ethernet Network to …

  Rs 232 rs 485