Direct Vent Gas Fireplace
Found 8 free book(s)
ASCENT™ 36 DIRECT VENT GAS FIREPLACE - Napoleon
www.napoleon.comASCENT™ 36 DIRECT VENT GAS FIREPLACE W415-1885 / 10.26.18 Specifications Front Options Rough Framing Model BTU Width Height Depth Viewing Area Actual Framing Actual Framing Actual Framing B36 18,000 35 35 1/2 34 5/8 35 15 3/4 16 23 11/16 X 30 11/16 Finish Framing 35 1/2" 90.2cm 35" 88.9cm 2 3/16" 55.6mm 8" 203.2mm 16" 40.6cm GAS T TION AL ...
ASCENT™ X 36 DIRECT VENT GAS FIREPLACE
www.napoleon.comASCENT™ X 36 DIRECT VENT GAS FIREPLACE W415-1887 / 10.26.18 Specifications Front Options Rough Framing Model BTU Width Height Depth Viewing Area Actual Framing Actual Framing Actual Framing GX36-1 26,000 (NG) 35 35 1/2 34 5/8 35 15 3/4 16 23 11/16 X 30 11/16 GX36-1 25,000 (P) 35 35 1/2 34 5/8 35 15 3/4 16 23 11/16 X 30 11/16 Finish Framing 35 ...
Installation & Maintenance Manual - Montigo
www.montigo.com• If you cannot reach your gas supplier, call the fire department. — Installation and service must be performed by a qualified installer, service agency or the gas fitter. Distinction INDOOR DIRECT VENT GAS FIREPLACE D3615, D3615ST Natural Gas or Propane Gas D4815, D4815ST Natural Gas or Propane Gas D7215, D7215ST Natural Gas or Propane Gas
DV400S DIRECT VENT ROOM HEATER OWNER’S MANUAL
downloads.hearthnhome.comAPPROVED FOR CANADA AND USA TO: ANSI Z21.88-1998 / CSA 2.33-M98 Vented Gas Fireplace Heaters, and applicable sections of UL307b Gas Burning Heating Appliances for Manufactured Homes and Recreational Vehicles, CAN/CGA 2.17-M91 Gas Fired Appliances for use at High Altitudes. This appliance is manufactured for operation with Natural Gas.
Installation and Appliance Setup - Care and Operation
downloads.hearthnhome.comThe Radiance Direct Vent Room Heater and its individual shut-off valve must be disconnected from the gas supply piping during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5 kPa). The Radiance Direct Vent Room Heater must be isolated from the gas supply piping system by closing its individual manual shutoff
Installer's Guide - Upflow/ Horizontal, Downflow ...
www.trane.comwhich must be gas tight and water tight. These Cate-gory IV Direct Vent furnaces are approved for installa-tion in Manufactured/ Mobile housing when used with BAYMFGH100A. ! CAUTION To prevent shortening its service life, the furnace should not be used as a “Construction Heater” during the finish-
Owner’s Manual S Top-Vent Gravity Wall Furnace
www.questargas.comavailable (either natural or L.P. gas). DO NOT convert the furnace from natural gas to L.P. gas or from L.P. gas to natural gas without the proper manufacturer’s gas conversion kit. Combustion air is drawn in from the room where the furnace is located and is vented out of the top of the furnace vertically through vent -----
Residential HVAC Worksheet
www.slcdocs.comAttach a complete gas pipe layout & sizing detail to the plan or permit application. If a manifold is used to connect the appliances on the horizontal, it shall be the same size as the vent. To the best of my knowledge, I certify that the information contained within this document is true, correct, and meets the requirements of the