Nace No 2 Sspc Sp 10
Found 8 free book(s)SURFACE PREPARATION STANDARD NO. 3
glavin.netSSPC-SP 1 Solvent Cleaning * SSPC-SP 2 Hand Tool Cleaning * SSPC-SP 7/ NACE No. 4 Brush-Off Blast Cleaning * SSPC-SP 11 Power Tool Cleaning to Bare Metal * SSPC-SP 15 Commercial Grade Power Tool Cleaning (2) Exact dimensions of equipment manufactured using S.I. units may vary slightly fro the S.I. values provided.
FY-22CH-1 21FEB2021
www.navsea.navy.milsubstituted for the degreasing/cleaning to SSPC-SP 1 and the brush-off blast to NACE 4/SSPC-SP 7. For cumulative surface areas less than 10 percent of the total area, with no individual area greater than 10 square feet, an SSPC-SP 3 cleaning followed by a fresh water wipe may be substituted for NACE 4/SSPC-SP 7.
Current Active Standards
www.sspc.orgSSPC-SP 10/ NACE No. 2 Near White Metal Blast Cleaning : January 2007 . SSPC-SP 11 Power Tool Cleaning to Bare Metal November 2013 SSPC-SP 13/NACE No. 6 Surface Preparation of Concrete : May 2018 . SSPC-SP 14 Industrial Blast Cleaning January 2007
CONTENTS 1 Scope and General Introduction 3 2 Surface ...
www.bharatpetroleum.comNear white metal (SSPC 10-63, NACE No.2, SA – 2.5) This provides a surface of about 95% as clean as white metal. Light shades and streaks are not allowed. Commercial blast (SSPC 6-63, NACE No.3, SA –2) This type of blast is more difficult …
REQUIREMENTS FOR PRESERVATION OF SHIP STRUCTURES
www.dcms.uscg.milPreparation Standard SSPC-SP 10/NACE No. 2, 2007, Near-White Blast Cleaning The Society for Protective Coatings (SSPC) Surface Preparation Specification No. 11 (SSPC-SP 11), 2013, Power Tool Cleaning to Bare Metal
STANDARD ITEM
www.navsea.navy.milNACE 4/SSPC-SP 7 of 2.5 and 2.10 to remove contaminants and loose paint. A thorough pressure wash of the area with fresh water at 3,000 to 5,000 pounds per square inch (PSI) may be substituted for the degreasing/cleaning to SSPC-SP 1 …
NACE No. 2/SSPC-SP 10 - psubs.org
www.psubs.orgNACE No. 2/SSPC-SP 10 Near-White Metal Blast Cleaning This NACE International (NACE)/SSPC: The Society for Protective Coatings standard represents a consensus of those individual members who have reviewed this document, its scope, and provisions. It is intended to aid the manufacturer, the consumer, and the general public.
SSPC-SP1 Solvent Cleaning
d1wg3emhath1s.cloudfront.netSSPC-SP 3 Power Tool Cleaning SSPC-SP3 details the use of power-assisted tools for surface preparation. The preparation method described here is intended to remove the same contaminants from a surface as in SSPC-SP2, and the procedures before and after using this cleaning method are identical to SSPC-SP2. The standard includes using rotary,