Pipe And Fittings
Found 6 free book(s)Instrument Pipe & ISO Conversion Fittings
www.parker.comParker Instrument Pipe Fittings part numbers are constructed from symbols that identify the size and style of the fitting and material used. The example shown below describes a male hex nipple for 3/8" NPT male pipe and 1/4" NPT male pipe in 316 stainless steel. Example: 6-4 MHN-SS Parker Instrument Pipe Fittings are ordered by part number as ...
BSP Pipe Fittings - Farnell
www.farnell.comBSP Pipe Fittings Suitable for most general industrial purposes Manufactured from extruded bar or hot brass stampings Reliable and corrosion resistant Technical Data Medium: Compressed air or any hydraulic fluids which are compatible with the materials indicated below. Operating Pressure: Dependent upon the type of tube being used, refer to
N-12 ST IB Pipe (per AASHTO)
assets.ads-pipe.combe installed by the pipe manufacturer and covered with a removable, protective wrap to ensure the gasket is free from debris. A joint lubricant available from the manufacturer shall be used on the gasket and bell during assembly. Fittings Fittings shall conform to AASHTO M252, AASHTO M294 or ASTM F2306. Bell and spigot connections shall utilize a
REFRIGERANT PIPING INTRODUCTION
www.rses.orgThe intervals or spacing of the supports will be governed by the type and size of pipe, but should be close enough to avoid any sagging between the supports. In order to be able to properly select the valves, fittings and pipe for an installation, and the connection of the equipment for
Pipe Fittings & Steel Nipples
www.pipe-valve-fitting.comPipe Fitting Product Line UÊ > i>L iÊ À Ê* «iÊ ÌÌ }Ã Threaded Fittings Class 150 (Standard) Class 300 (XS/XH) UÊ >ÃÌÊ À Ê* «iÊ ÌÌ }Ã Threaded Fittings Class 125 (Standard) Class 250 (Extra Heavy) Flanged Fittings Class 125 (Standard) Class 250 (Extra Heavy) Drainage Fittings UÊ- …
HOSE BARB BRASS FITTINGS Hose Barb Fittings - Hayward …
www.haywardpipe.comCA360 Brass for Barstock fittings. CA377 Brass for Forged fittings. Note: These fittings are intended for use with hose clamp, similar type clamp or a crimped ferrule. • Assembly Instructions 1- Cut hose cleanly and squarely to length. 2- Slide clamp on hose. 3-Lubricate hose. Push hose on fitting until hose bottoms against stop ring or hex.