Search results with tag "Fittings fittings"
Coatings on Valves and Fittings - Wallis Eng
walliseng.netMJ Fittings Fittings are coated per AWWA C116 – Protective Fusion-Bonded Epoxy Coatings for the Interior and Exterior Surfaces of Ductile-Iron and Gray-Iron Fittings.Epoxy coating is applied to both the interior and exterior surfaces, typically with a 4 mil minimum
B16.9-2001 7/23/01 2:40 PM Page 1 ASME B16.9-2001 …
www.zaporarm.ruFACTORY-MADE WROUGHT BUTTWELDING FITTINGS 1 SCOPE 1.1 General This Standard covers overall dimensions, tolerances, ratings, testing, and markings for wrought factory-made buttwelding fittings in sizes NPS 1⁄ 2 through 48 (DN 15 through 1200). 1.2 Special Fittings Fittings may be made to special dimensions, sizes,
N-12 ST IB Pipe (per AASHTO)
assets.ads-pipe.combe installed by the pipe manufacturer and covered with a removable, protective wrap to ensure the gasket is free from debris. A joint lubricant available from the manufacturer shall be used on the gasket and bell during assembly. Fittings Fittings shall conform to AASHTO M252, AASHTO M294 or ASTM F2306. Bell and spigot connections shall utilize a
ADS N-12 WT IB PIPE (PER ASTM F2648) SPECIFICATION
assets.ads-pipe.comFittings Fittings shall conform to ASTM F2306. Bell and spigot connections shall utilize a welded bell and valley or saddle gasket meeting the watertight joint performance requirements of ASTM F2306. Field Pipe and Joint Performance To assure watertightness, field performance verification may be accomplished by testing in accordance with ASTM ...