Resistor Surface Mount
Found 6 free book(s)
MP900 and MP9000 Series Kool-Pak Power Film Resistors TO ...
www.caddock.comterminals shorted, and the metal surface the part is mounted to or a metal clip in contact with the top surface of the part. Insulation Resistance: 10,000 Megohms min. The resistor element is electrically isolated from the mounting surface. Load Stability: 2,000 hours at rated power. ∆R ±(1.0 percent + 0.0005 ohm) max. Power
Commercial Thin Film Chip Resistor, Surface-Mount Chip
www.vishay.comCommercial Thin Film Chip Resistor, Surface-Mount Chip These chip resistors are available in both “top side” and “wraparound” termination styles in a variety of sizes. They incorporate self passivated, enhanced Tantalum Nitride films, to give superior performance on …
Power Metal Strip Resistors, Low Value (Down to 0.0005 Ω ...
www.vishay.com(Down to 0.0005 Ω), Surface-Mount ... • Part marking: value; tolerance: due to resistor size limitations some resistors will be marked with only the resistance value (1) For values above 0.1 Ω derate linearly to 80 % rated power at 0.5 (2) WSL1206 0.0005 Ω to 0.00099 is only available with 2 % tolerance ...
PowerFlex 70 Adjustable Frequency AC Drive
literature.rockwellautomation.comIt helps maintain long-term surface insulation resistance, ensuring operational integrity of the assembly. ... • Internal dynamic brake resistor requires no extra panel space, and supplies a large amount of braking torque for short periods. ... G Wall/Machine Mount - IP54, NEMA/UL Type 12(3) A (3)
DAC0808 8-Bit D/A Converter (Rev. A) - TI.com
www.ti.comSurface Mount Package Vapor Phase (60 seconds) 215˚C Infrared (15 seconds) 220˚C Operating Ratings ... and load resistor of 2.5 kΩbetween pin 4 and ground will yield a voltage output of 256 levels between 0 and −4.980V. Floating pin 1 …
FS1406 µPOL - TDK
product.tdk.comPull up to bus voltage with a .kΩ resistor. If unused tie to AGnd. 2 PG Power Good status. Open drain of an internal MOSFET. Pull up to V CC – pin 10 or an external bias voltage (Figure 7) – with a .kΩ resistor. 3 En Enable. Switches the FS1406 on and off. Can be used with two external resistors to set an external UVLO (Figure 6).