Slave Serial And Ethernet
Found 10 free book(s)
MODBUS MASTER/SLAVE Serial and Ethernet …
media.klinkmann.comMODBUS MASTER/SLAVE Serial&Ethernet Comm. Server Ver 1.x User Manual Rev 2.2 380xxm22 MASTER/SLAVE Server “OPC & DDE” version is tested for compliance and is compatible with OPC Foundation OPC Data Access Compliance Test Tool. The Suite Link, FastDDE (Version 3) and DDE support for MODBUS MASTER/SLAVE ...
MicroLogix™ 1500 Controller to MicroLogix 1400 or ...
literature.rockwellautomation.comSlave I/O With 1769-SDN N/A N/A With 1769-SDN EtherNet/IP With 1761-NET-ENI or 1761-NET-ENIW Single EtherNet/IP port Dual-port EtherNet/IP support Dual-port EtherNet/IP support DH-485 Network with 1761-NET-AIC Network with 1763-NC01 N/A N/A SCADA RTU ... CIP Serial N/A N/A Yes Yes Agency Certifications CE, RCM, EAC, KC, UL, and C-UL
Compact 5000 I/O Serial Module - Rockwell Automation
literature.rockwellautomation.comThis manual describes how to use Compact 5000™ I/O serial module in Logix 5000™ systems. Make sure that you are familiar with the following: • Use of a Logix 5000™ controller • Use of an EtherNet/IP™ network, if the serial module is installed in a remote location that is accessible via the EtherNet/IP network.
2/3-Port EtherCAT® Slave Controller with Integrated ...
ww1.microchip.comThe LAN9252 is a 2/3-port EtherCAT slave controller with dual integrated Ethernet PHYs which each contain a full- duplex 100BASE-TX transceiver and support 100Mbps (100BASE-TX) operation. The LAN9252 supports HP Auto-
Datasheet - STM32H742xI/G STM32H743xI/G - 32-bit Arm ...
www.st.com• 4x SAIs (serial audio interface) • SPDIFRX interface • SWPMI single-wire protocol master I/F • MDIO Slave interface • 2× SD/SDIO/MMC interfaces (up to 125 MHz) • 2× CAN controllers: 2 with CAN FD, 1 with time-triggered CAN (TT-CAN) • 2× USB OTG interfaces (1FS, 1HS/FS) crystal-less solution with LPM and BCD
Datasheet - STM32H750VB STM32H750ZB STM32H750IB ...
www.st.com• 4x SAIs (serial audio interface) • SPDIFRX interface • SWPMI single-wire protocol master I/F • MDIO Slave interface • 2× SD/SDIO/MMC interfaces (up to 125 MHz) • 2× CAN controllers: 2 with CAN FD, 1 with time-triggered CAN (TT-CAN) • 2× USB OTG interfaces (1FS, 1HS/FS) crystal-less solution with LPM and BCD
Xilinx DS160 Spartan-6 Family Overview
www.xilinx.commaster SelectMAP mode generates the CCLK signal while slave SelectMAP mode receives the CCLK signal for the 8- and 16-bit-wide transfer. In master serial mode, the beginning of the bitstream can optionally switch the clocking source to an external clock, which can be faster or more precise than the internal clock.
LPC546xx Product data sheet
www.nxp.comSerial interfaces: Flexcomm Interface contains up to ten serial peripherals. Each Flexcomm Interface can be selected by software to be a USART, SPI, or I2C interface. Two Flexcomm Interfaces also include an I 2S interface. Each Flexcomm Interface includes a FIFO that supports USART, SPI, and I2S if supported by that Flexcomm Interface. A
TJA1100 100BASE-T1 PHY for Automotive Ethernet
www.nxp.comThe TJA1100 is a 100BASE-T1 compliant Ethernet PHY optimized for automotive use cases. The device provides 100 Mbit/s transmit and receive capability over a single Unshielded Twisted Pair (UTP) cable, supporting a cable length of up to at least 15 m. Optimized for automotive use cases such as IP camera links, driver assistance systems
Data communication with Victron Energy products s
www.victronenergy.comEthernet Modbus-TCP Modbus-TCP Battery monitoring BMV-600S, BMV-602S and BMV-600HS BMV-60xS Text (TTL) CAN and BMV Text Via interface BMV-700 and BMV-700H VE.Direct VE.Direct Direct or via interface Inverters Phoenix Inverter models from 1200 to 5000VA VE.Bus CAN and MK2/MK3 Via interface