Example: bankruptcy
Search results with tag "Bltouch"
BLTouch auto bed levelling sensor setup - Locxess
locxess.dePrepare > Move axis > Move 0.1mm > Move Z Slowly move the Z axis down until you have the correct first layer gap (paper or thin card method) Note the distance on the display e.g. 0.6 mm (0.6 mm is example, note your actual) Use this formula to determine your Z offset needed: Z offset = -2 + 0.6 Z offset = -1.4mm
BLTouch: Auto Bed Leveling Sensor for 3D Printers
cdn-3d.niceshops.comWhen each EEPROM command (S130, S140, S150) is completed, the 10ms red LED is turned on once or twice. The last command for mode conversion (S140 or S150) will be activated immediately and the 10ms red LED flashes two times. Please don't mix up the sequence. If the correct order and minimum retention time are not observed, a retry may be required.