Search results with tag "Epoxy mortar"
REPAIR, RESTORATION AND STRENGTHENING OF …
www.nicee.org9.33 Epoxy mortar For larger void spaces, it is possible to com-bine epoxy resins of either low viscosity or higher viscosity, with sand aggregate to form epoxy mortar. Epoxy mortar mixture has higher compressive strength, higher tensile strength and a lower modulus of elasticity than Portland cement concrete. Thus the mortar is not a stiff ...
Dura-Plate Epoxy Mortar - A-LOK
www.a-lok.comDura-Plate 100 Epoxy Mortar provides concrete and masonry surfaces with increased chemical and abrasion resistance. The three-part, resin aggregate system forms a trowelable epoxy mortar that applies easily to overhead and vertical concrete surfaces. When cured, Dura-Plate 100 Epoxy Mortar …
Coatings MasterSeal 350 - Master Builders Solutions
assets.master-builders-solutions.comEPOXY MORTAR 1.Mix the two components of MasterSeal 350 using the recommended procedures under the Mixing section. 2.Slowly add up to five parts by volume of oven-dried sand to one part of mixed epoxy. 3.For larger applications, a paddle-type (mortar) mixer may be used. However, the A and B components must first be mixed together using
03 35 00 - Concrete Finishing - Bay Area Rapid Transit
webapps.bart.gov301. When using epoxy mortar, conform with applicable requirements of ACI 503.4. B. Surface Defects: 1. Repair of surface defects shall begin immediately after form removal. For repair with epoxy mortar, concrete shall be dry. 2. Surface defects are defined to include: form-tie holes, air voids or pockets, bug holes with
Premium Epoxy Grout and Mortar
www.mapei.comDESCRIPTION Kerapoxy is a premium-grade, water-cleanable, 100%-solids, high-strength epoxy mortar and chemical-resistant nonsagging grout. Available in all MAPEI colors for grouting, Kerapoxy is excellent for countertops, high-traffic areas, and areas needing stain and chemical resistance.
ARDEX WPM 300 - ARDEX Australia
ardexaustralia.com300 epoxy mortar or ARDEX concrete repair systems and allowed to cure for 2–3 hours before coating is applied. Installation Each component should be individually mixed to form a homogenous component. Thoroughly mix the two components in the ratio of 1:1