Search results with tag "Torque limiters"
CENTAFLEX-A
www.centa.infoTORQUE LIMITERS Load holding torque limiters are available for all CENTAFLEX-A designs, suitable for mounting either in the middle tube as well as on the generator shaft. Supplied with pre-set slip-through torque and individual calibration protocol.
VA-LCP Olecranon Plates 2.7/3.5. The fracture-specific low ...
synthes.vo.llnwd.net03.110.002 Torque Limiter, 1.2 Nm, with AO/ASIF Quick Coupling 03.110.005 Handle for Torque Limiters 0.4/0.8/1.2 Nm Note: When inserting screws at the nominal angle, screws should not collide with other screws in the same plate. Precautions: – The use of variable angle in close proximity to another
Timing Belt Catalogue - feyc.eu
feyc.euinclude Roller Chain and Sprockets, Couplings, Torque Limiters, Sprag Clutches and Timing Belt Drives, whilst in the U.S.A. by acquisition Morse also included the Denver Gearbox Range and the Sealmaster Bearing Products. In 1987 Cross & Morse closed the Letchworth plant and centralised all production at the 10,000 sq. metre factory in
PTO PARTS: SLIP CLUTCHES-TORQUE LIMITERS-ADAPTERS ...
www.powellequipmentparts.com3/78 PTO PRODUCTS Slip Clutches to fit Domestic Drivelines PARTS BREAKDOWN FOR 125-801 1 3/8 - 6 SPLINE HUB x 1 3/8 - 6 mALE SHAFT SLIP CLUTCH PART NO. 125-802 2-PLATE
Torque Limiters & Couplings - Cross and Morse are …
www.cross-morse.co.uk4 Standard Torque Limiters Original Morse Series Torque Limiters Developed from the original Torque Limiters produced in 1949, these well proven units are based on Imperial
TORQUE LIMITERS TORQUE LIMITER COUPLINGS - …
www.hercus.com.auRegency Park © Copyright Hercus 2008. While every care has been taken to ensure the accuracy of information contained in this data sheet, but no liability can be ...
LCP Extra-articular Distal Humerus Plate. The anatomically ...
synthes.vo.llnwd.net511.770/773 Torque Limiter, 1.5 Nm 397.705/ Handle for Torque Limiter Nos. 511.770 311.431 and 511.771/Handle with Quick Coupling Insert the centering sleeve into the LCP drill sleeve (1). Insert the LCP drill sleeve assembly into the most distal lock-ing hole until fully seated. Insert a 1.6 mm Kirschner wire through the centering sleeve
3M Separation and Purification Sciences 3M Zeta Plus Depth ...
multimedia.3m.comsmall holder has a built-in torque limiter that will signal the operator when the holder assembly is properly sealed. All small holders have been designed to be fully autoclavable for applications where that may be required. 3M™ Encapsulated System Holders, Large (Model# 16EZB) The large holder can accommodate up seven 1.6 m² (dual layer)
Installation and maintenance manual 200 series …
www.autogard.comAG Manual 200-97 3 MODEL 205 This model includes an Autoflex coupling which can accommodate 0.5° of angular misalignment. After fitting the Autoflex hub (2) and the torque limiter onto the shafts, the gap between the face of the Autoflex hub (2) and the adaptor (10) should be checked at several positions around the