Search results with tag "In circuit"
ST-Link V2 in circuit debugger programmer for STM8 and ...
www.st.comST-LINK/V2 in-circuit debugger/programmer for STM8 and STM32 Introduction The ST-LINK/V2 is an in-circuit debugger/programmer for the STM8 and STM32 microcontrollers. The single wire interface module (SWIM) and the JTAG/serial wire debugging (SWD) interfaces facilitate the communication with any STM8 or STM32
PIC18(L)F27/47K40 Data Sheet - Microchip Technology
ww1.microchip.comProgramming/Debug Features • In-Circuit Serial Programming ™ (ICSP ) via Two Pins • In-Circuit Debug (ICD) with Three Breakpoints via Two Pins • Debug Integrated On-Chip PIC18(L)F27/47K40 Family Types Table 1. Devices included in this data sheet Device Program Memory Flash (bytes) Data SRAM (bytes) Data EEPROM (bytes) I/O Pins imers ...
PIC16(L)F1826/27 Data Sheet - Microchip Technology
ww1.microchip.com• In-Circuit Serial Programming™ (ICSP™) via two pins • In-Circuit Debug (ICD) via two pins • Enhance Low-Voltage Programming • Power-Saving Sleep mode Extreme Low-Power Management PIC16LF1826/27 with nanoWatt XLP: • Operating Current: 75 A @ 1 MHz, 1.8V, typical • Sleep mode: 30 nA • Watchdog Timer: 500 nA
PM0075 Programming manual - STMicroelectronics
www.st.comICP (in-circuit programming): ICP is the ability to program the Flash memory of a microcontroller using the JTAG protocol, the SWD protocol or the boot loader while the device is mounted on the user application board. I-Code: this bus connects the Instruction bus of the Cortex-M3 core to the Flash instruction interface.
CC USB Software Examples User's Guide - TI.com
www.ti.comswru222 3/22 3 4 Getting Started 4.1 Preparations The USB firmware described in this document may be debugged using any of the following In-Circuit
CC1111/CC2511 USB HW User’s Guide - TI.com
www.ti.comswru082b 7/12 6 Using SmartRF04EB as an In-Circuit Emulator (ICE) The debug interface on the SmartRF04EB is controlled by the USB MCU. This allows both programming