Search results with tag "Extension nozzle"
IF YOU HAVE QUESTIONS OR CONCERNS, OR ARE MISSING …
cobbcarpet.comPROBLEM: Bad spray pattern or low spray volume. CAUSE: Extension nozzle clogged with dirt or damaged. SOLUTION: Remove nozzle and clean.Remove extension and clean. If extension cannot be unclogged, replace it. PROBLEM: Nozzle leaks when flow control is closed. CAUSE: (1) Extension o-ring prevented from sealing by dirt or damage. OR (2) Nozzle is worn. ...
Simpson Strong-Tie SET-XP High-Strength Epoxy Adhesive
www.buildsite.comModification or improper use of mixing nozzle may impair SET-XP adhesive performance. 4. Two EMN22I mixing nozzles and two nozzle extensions are supplied with each cartridge. 5. One EMN22I mixing nozzle and one nozzle extension are supplied with each cartridge. Cure Schedule Base Material Temperature Gel Time (minutes) Cure Time °F °C (hrs ...
Injection Molding Guide - Lubrizol
www.lubrizol.comA straight, open nozzle with a full internal taper tip is recommended. A positive-shut-off, antidrool nozzle can be helpful but is not a necessity. If the particular machine or mold design requires a long nozzle or a nozzle extension, it should be well insulated with heater bands so that there are no cold spots. The harder TPU compounds,