Transcription of 310 281 - GB - Timeguard
1 310 281 06tOperating instructionsSYN 161 hSUL 181 hGMOUNTING INSTRUCTIONS Safety information:Electrical devices should only be connectedand mounted by an electrical specialist. Manipulations and modi-fications on the switch will result in loss of warranty. The nationalspecifications and applicable safety regulations must be 230 V / 50 HzQuartz * R = 3d (72h) LiMh230 V / 45 60 Hz16 A250 * The quartz movement starts automatically aftera few minutes by an applied voltage. The fullpower reserve is built up after about 3 h ProgrammmanualiGManual Control ON/OFF (Override Control)Turn the control axis in direction of arrow by one notch; ON=+ or OFF = -. The manual control is automaticallyannuled by the following counteracting command of the automaticprogram ON / OFFiGPermanent Control ON/OFFSet the hand lever to perm = permanent control; turning thecontrol axis in direction of arrow, the required permanent con-trol ON or OFF can now be adjusted.
2 Turning the hand lever to Auto = Automatic Control, the permanent control is actual switch position is maintained until the next counterac-ting command of the automatic program sequence is triggered. Animmediate correction can be carried out by means of the manualcontrol (override control).EMV / CEM / EMC / ETYGThe time switches are in accordance with the European direc-tives 73/23/EEC. (Low-Voltage Directive) and 89/336/EEC (EMC-Directive). If the time switches are used together with other devi-ces in an installation, take care that the complete installationdoes not cause a radio AGPostfach 56, D-72394 HaigerlochTelefon (0 74 74) 692-0, Telefax: (0 74 74) 692 150 KundendienstTelefon (0 74 74) 692-177, Telefax (0 74 74) 692-207 Timeguard LTD,Victory Park, 400 Edgware RoadLondon NW2 6 NDTel. 0181/4508944;Fax: 0181/4525143o PETER WARBURTON PTY. LIMITED,64 Brittania Road, Castle HillNSW 2154, Australia,Tel.
3 : (02) 9899 2908,Fax: (02) 9899 4486 AUS
