8% Hydrogen Peroxide - adc-chem.com

1 American Development Corporation821 William D. Jones Blvd, Fayetteville TN 37334888-542-8561 Fax - 931-438-2673 Safety Data SheetThis Material Safety Data Sheet conforms to the requirements of ANSI This MSDS complies with 29 CFR (Hazard Communication Standard) Read this MSDS before handling & disposing of this product. Section 1: Material Identification and Company IdentificationProduct Identity:8% Hydrogen PeroxideDistributed By:American Development CorporationAddress:821 William D. Jones :Fayetteville TN 37334 Phone:888-542-8561 Chem-Tel800-255-3924 Section 2: Hazardous IngredientsComponentCAS Peroxide7722-84-18%OxidizerWater7732-18- 592%n/aSection 3: Hazards IdentificationPrimary routes of exposure: Skin or eye contact, if Health Effects:Eyes:Can cause severe burns and permanent damage to :Can cause severe burns with deep ulceration :Can cause severe irritation and/or burns to the entire gastrointestinal tract,characterized by nausea, abdominal pain and possible.

2 Mist can cause irritation to information appearing in this document is based upon data obtained from the product manufacturer and/or supplier. While the information is believed to be pertinent and accurate, no warranty expressed or implied is given to it's accuracy. This MSDS is to be used as a guideline for safe work practices and emergency 1 of 58% Hydrogen PeroxideSection 4: First Aid MeasuresEye Contact:Immediately flush with large amounts of water for at least 15 minutes. Seek medical attention Contact:Immediately wash the affected area with large amounts of water while removing contaminated clothing.

3 Call a :If person is conscious give large amounts of water to drink. Do not induce vomiting. Seek medical attention :Move to fresh air. Support respiration. Call a to Physician: Hydrogen Peroxide at this concentration is a oxidant. Skin contact may be irratating; eye contact may be severely irritating. Treatment is by dilution and is symptomaticand 5: Fire Fighting Measures:Extinguishing Media:Flood with water. On decomposition releases oxygen which may intensify Point, Deg F:Not FlammableNFPA Rating:Health1 Fire0 Reactivity1 HazardOxidizerSection 6: Accidental Release Measures:Release Notes:Wear recommended PPE.

4 Dilute with a large volume of water and hold in a diked area until Hydrogen Peroxide may be aided by adding sodium metabisulfite orsodium sulfite after diluting to approximately 5%.Combustible materials exposed to Hydrogen Peroxide should be immediately rinsed with large amounts of water. Residual Hydrogen Peroxide that is allowed to dry on organic materials such as paperfabrics, leather, wood etc. can cause the material to information appearing in this document is based upon data obtained from the product manufacturer and/or supplier.

5 While the information is believed to be pertinent and accurate, no warranty expressed or implied is given to it's accuracy. This MSDS is to be used as a guideline for safe work practices and emergency 2 of 58% Hydrogen PeroxideSection 7: Handling and Storage:Handling:Wear goggles and a face shield, impervious clothing such as rubber, PVC, etc. and rubber or neoprene gloves and shoes. Avoid cotton, wool and :Avoid excessive heat and product contamination. Store in vented container. Do not store drums on wooden pallets. Empty containers should be triple utensils should only be made of glass, stainless steel, aluminumor 8: Exposure Controls/Personal ProtectionControl Measures:Ventilation should be provided to minimize the release of vaporsand mists into the work environment.

6 Spills should be minimized or confined to prevent release into the work area. Remove contaminatedclothing immediately and wash thoroughly before Personal Protective Equipment:Respirator:If concentrations in excess of 10ppm are expected, use NIOSH/DHHS approved SCBA. DO NOT use any form of air-purifying respirator orfiltering face piece (common dust mask), especially those containing oxidizable sorbants such as activated :Chemical goggles, face shieldGloves:Neoprene, PVC or rubber gloves. Do not use cotton or woolor :Impervious clothing such as an approved splash suit made ofSBR rubber, PVC, or specialized HazMat protective should be made of NBR, PVC, polyurethane or neoprene.

7 Other protective measures:Emergency eye wash and safety showers for first aid should be available near work 9: Physical PropertiesAppearance:ClearSpecific State:LiquidDensity (lbs/gal) - Threshold:n/a% Volatile100%Boiling Point:216 FSolubility100%Freezing Point:23 FFlash PointNon-combustibleThe information appearing in this document is based upon data obtained from the product manufacturer and/or supplier. While the information is believed to be pertinent and accurate, no warranty expressed or implied is given to it's accuracy.

8 This MSDS is to be used as a guideline for safe work practices and emergency 3 of 58% Hydrogen PeroxideSection 10: Stability and ReactivityStability:Stable under normal conditionsPolymerization:Will not occurConditions to avoid:Avoid contact with leather, wool, acids, organic materials:Reducing agents, wood, paper and other combustibles, iron, andother heavy metals, copper alloys and decomposition products: Oxygen which supports 11: Toxicological InformationMedical conditions aggravated by exposure:Target Organs:Corrosive to all body tissues by all routes of exposure.

9 Primary routes of exposure: eyes, skin, mucous membranes, 12: Ecological InformationEnvironmental Fate: Hydrogen Peroxide in the aquatic environment is subject to various reduction or oxidation processes and decomposes into water and oxygen. Half life infreshwater ranged from 8 hours to 20 days, in air from 10-20 hrs. And in soilsfrom minutes to hours depending upon microbiological activity. Section 13: Disposal ConsiderationsAn acceptable method of disposal is to dilute with a large amount of water and allow thehydrogen Peroxide to decompose followed by discharge into a suitable treatment systemin accordance with all regulatory agencies.

10 The appropriate regulatory agencies should becontacted prior to information appearing in this document is based upon data obtained from the product manufacturer and/or supplier. While the information is believed to be pertinent and accurate, no warranty expressed or implied is given to it's accuracy. This MSDS is to be used as a guideline for safe work practices and emergency 4 of 58% Hydrogen PeroxideSection 14: Transportation Proper Shipping Name: Hydrogen Peroxide , aqueous solutions with not less than8% but less than 20% Hydrogen Hazard number:2984 Packing Labels:Primary: Placards:Oxidizer Emergency Response Guidebook Number140 Section 15: Regulatory InformationTSCA Inventory Status:YesSARA - 313 Listed Chemicals:NoRCRA Hazardous Waste Number:NoCERCLA:YesReportable Quantity:1,000 poundsSection 16.