AIR CONDITIONER Contents Wall Mounted Type

1 En-1 PART NO. 9333003054 Espa olFran aisEnglishAIR CONDITIONERWall Mounted TypeOPERATING MANUALB efore using this product, read these instructions thoroughly and keep this manual for future PrecautionsTo prevent personal injury to others, or property damage, read this section carefully before you use this product, and be sure to comply to the following safety operation due to failure to follow the instructions may cause harm or damage, the seriousness of which is classifi ed as follows: WARNING CAUTIONThis mark warns of death or serious mark warns of injury or damage to property. WARNING Do not attempt to install this air CONDITIONER by yourself. This unit contains no user-serviceable parts. Always consult authorized service personnel for repairs. When moving, consult authorized service personnel for disconnection and installation of the unit. Do not become excessively chilled by staying for lengthy periods in the direct cooling airfl ow.

2 Do not insert anything into the Airfl ow direction. Do not start and stop air CONDITIONER operation by disconnecting the power supply cord. Take care not to damage the power supply cord. If the power supply cord of this appliance is damaged, it should only be replaced by the authorized service personal, since special purpose tools and specifi ed cord are required. In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the breaker, and consult authorized service personnel. In the event of refrigerant leakage, be sure to keep away from fi re or any fl ammables. (consult an authorized service personnel) CAUTION Provide occasional ventilation during use. Do not direct airfl ow at fi replaces or heating apparatus. Do not climb on, or place objects on, the air CONDITIONER . Do not hang objects from the indoor unit. Do not set fl ower vases or water containers on top of air conditioners .

3 Do not place any other electrical products or household belongings under indoor unit or outdoor unit. Dripping condensation from the unit might get them wet, and may cause damage or malfunction of your property. Do not expose the air CONDITIONER directly to water. Do not operate the air CONDITIONER with wet hands. Do not pull power supply cord. Turn off power source when not using the unit for extended periods. Check the condition of the installation stand for damage. Do not place animals or plants in the direct path of the airfl ow. Do not drink the water drained from the air CONDITIONER . Do not use in applications involving the storage of foods, plants or animals, precision equipment, or art works. Do not touch the aluminum fi ns of heat exchanger built-in the indoor or outdoor unit to avoid personal injury when you install or maintain the unit. Connection valves become hot during Heating; handle with care.

4 Do not apply any heavy pressure to radiator fi ns. Operate only with air fi lters installed. Do not block or cover the intake grille and outlet port. Ensure that any electronic equipment is at least 40 in. (1 m) away from either the indoor or outdoor units. Avoid installing the air CONDITIONER near a fi replace or other heating apparatus. When installing the indoor and outdoor unit, take precautions to prevent access to infants. Do not use infl ammable gases near the air CONDITIONER . This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the Precautions .. En-1 Indoor Unit Overview and Operations .. En-2 Remote Controller Overview and Operations.

5 En-3 Timer En-5 General Informations on Operation .. En-6 Cleaning and En-6 Troubleshooting .. 111/5/2013 4:03:04 PM11/5/2013 4:03:04 PMEn-2 OPERATING MANUAL1 Intake grilleBefore starting operation, make sure that the intake grille has been shut completely. Incomplete closing might have an effect on the proper working or performance of the AUTO buttonUse when you lost the remote controller or remote control malfunction or operationIn operationPress more than 3 more than 3 seconds and less than 10 more than 10 seconds.(Only for servicing.*)Forced coolingAfter cleaningPress less than 3 indicator reset*:To stop forced cooling, press this button or START/STOP button on the remote panel4 Vertical airfl ow direction louverEach time you press SET button on the remote controller, the angle of the vertical airfl ow direction louver moves as follows:1234567 COOL or DRY modeHEAT mode123765**4*: Default setting in each mode.

6 Do not adjust by hand. At the beginning of AUTO or HEAT mode, they may stay position 1 for a while for adjustment. If you set the angle to position 4 7 for more than 30 minutes in COOL or DRY mode, they automatically return to position 3. In COOL or DRY mode, if the angle is set to position 4 7 for many hours, condensation may be formed, and the drips may wet your diffuserIn conjunction with movement of the vertical airfl ow direction louver, the angle of the power diffuser moves as follows:Vertical airfl ow direction louverPower diffuser37654213214 In SWING operation, power diffuser does not hose7 Remote control signal receiver CAUTIONFor appropriate signal transmission between remote controller and the indoor unit, keep the signal receiver away from following items: - Direct sunlight or other strong light - Flat-panel television screenIn rooms with instantaneous fl uorescent lights, such as inverter type ones, the signal may not be transmitted properly.

7 In such a case, consult the store that you purchased the indicator (green)Lights in ECONOMY operation and in MIN. HEAT indicator (orange)Lights in TIMER operation, and blinks slowly when the timer setting error is for the timer setting error, refer to Auto-restart function on page indicator (green)Lights in normal operation, and blinks slowly in automatic defrosting airfl ow direction louvers CAUTIONB efore you adjust the horizontal airfl ow direction, make sure that the vertical airfl ow direction louver has been stopped two knobs by page 6 BAir fi lterEasy-to-care air fi lters resist mildew page 7 CAir cleaning fi ltersPurify or deodorize the air, and provide fresh airfl ow. Indoor unit accessoriesRemote controllerBatteriesAir cleaning fi ltersFilter holdersRemote controller holderTapping screws(M3 12 mm) WARNINGTake care to prevent infants and young children from accidentally swal-lowing the controller holder installation321 ScrewsInsertSlide upIndoor Unit Overview and 211/5/2013 4:03:20 PM11/5/2013 4:03:20 PMEn-3 AIR CONDITIONER Wall Mounted TypeOPERATING MANUAL CAUTION To prevent malfunction or damage of the remote controller: - Place remote controller at where will not be exposed to direct sunlight or excessive heat.

8 - Remove batteries if the product is not going to be used for an extended period. - Exhausted batteries must be removed immediately, and be disposed according to the local laws and regulations of your region. If leaking battery fl uid comes in contact with your skin, eyes, or mouth, immediately rinse with plenty of clean water, and consult your physician. Obstacles such as a curtain or wall between the remote controller and the indoor unit may affect the appropriate signal transmission. Do not apply strong shocks to the remote controller. Do not pour water on the remote controller. Do not attempt to recharge dry (R03/LR03/AAA 2) loading and remote controller preparation142357685 Press CLOCK ADJUST button to start clock Set the time by pressing SELECT time you press the button, the value increases or decreases 1 minute. With pressing and holding the button, the value increasesor decreases 10 minutes.* By pressing the TEMP.

9 ( ) buttons, the time indicator can be changed from a 24-hour to a 12-hour Press the CLOCK ADJUST button again to complete the clock Press the C / F button to select the preferred temperature unit. (Factory setting is F.)Notes: Use specifi ed type of battery only. Do not use new battery and used battery together. Batteries can be used about 1 year in ordinary use. If the remote control range noticeably got shorten, replace the batteries, and press RESET Controller Overview and OperationsYou can quickly start the operation with following 3 steps:1 START/STOP button2 MODE buttonSwitches operation mode in following COOL DRY FAN HEATN otes in HEAT mode: At the beginning of the operation, the indoor unit operates at very low fan speed for about 3 5 minutes for preparation, and then switches to the selected fan speed. Automatic defrosting operation overrides the heating operation when it is SET TEMP.

10 (temperature) buttonsSet desired COOL/DRY mode, the value needs to be set at lower temperature than current room temperature, and in HEAT mode, the value needs to be set at higher temperature than current room , corresponding operation mode does not start to setting rangeAUTO/COOL/DRY64-88 F (18-30 C)HEAT60-88 F (16-30 C)*:Temperature control is not available in FAN mode. 4 Remote controller displayIn this section, all the possible indicators are displayed for description. In actual operation, the display is linked with the button operation, and only shows the necessary indicators for each setting.(continued) 311/5/2013 4:03:23 PM11/5/2013 4:03:23 PMEn-4 OPERATING MANUAL5 POWERFUL buttonThe product will operate at maximum power, which is convenient when you want to quickly cool down or warm up the you press the button to start the POWERFUL operation, the indoor unit emits 3 short operation is automatically turned off in the following situations: Adjusted room temperature reached to the defi ned temperature in temperature setting in COOL, DRY, or HEAT mode.