Transcription of Bridge Rectifier - Farnell element14
1 Bridge RectifierPage <1>05/07/11 : glass passivated . Surface mount. Ideal for printed circuit board. Low forward voltage drop, high current capability. Reliable low cost construction utilizing moulded plastic technique resultsin inexpensive Voltage - 1,000 VForward Current - 1 AmpereMechanical DataPolarity : As marked on : oz, position : : Inches (Millimetres) Bridge RectifierPage <2>05/07/11 Recurrent Peak Reverse VoltageVRRM1,000 VMaximum RMS VoltageVRMS700 Maximum DC Blocking VoltageVDC1,000 Maximum Average Forward Rectified Currentat TA= 40 CI(AV)1 APeak Forward Surge ms Single Half Sine-waveSuper Imposed on Rated Load (JEDEC Method)IFSM30 Maximum Forward Voltage at 1 A DC Reverse Currentat TJ = 25 Cat Rated DC Blocking Voltageat TJ= 125 CIR10500 AI2t Rating for Fusing (t < ms) Junction Capacitance Per Element (Note 1)CJ25pFTypical Thermal Resistance (Note 2)R JA40 C/WOperating Temperature RangeTJ-55 to +150 CStorage Temperature Range TSTGN otes :1.
2 Measured at 1 MHz and applied reverse voltage of 4 V Thermal resistance from junction to ambient mounted on P C B with (13 13 mm) copper and Characteristics CurvesAverage Forward CurrentAmperesForward Current Derating CurveAmbient Temperature, ( C)Maximum Non-Repetitive Surge CurrentPeak Forward Surge Current,AmperesNumber of Cycles at 60 HzMaximum Ratings and Electrical CharacteristicsRating at 25 C ambient temperature unless otherwise phase, half wave, 60 Hz, resistive or inductive capacitive load, derate current by 20%. Bridge RectifierPage <3>05/07/11 Junction CapacitanceReverse Voltage, (Volts)Capacitance, (pF)Typical Forward CharacteristicsInstantaneous Forward Voltage, VoltsInstantaneous Forward Current, (A)Rating and Characteristics CurvesTypical Reverse CharacteristicsInstantaneous Reverse Current, ( A)Percent of Rated Peak Reverse Voltage, (%)Important Notice : This data sheet and its contents (the "Information") belong to the members of the Premier Farnell group of companies (the "Group") or are licensed to it.
3 No licence is granted for the use ofit other than for information purposes in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replacesall data sheets previously supplied. The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any usemade of it. Users of this data sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or for loss or damage resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising)is excluded.
4 This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. Multicomp is the registered trademark of the Group. Premier Farnell plc 2011.
