Example: confidence
CHEAT SHEET TOPICS AND TROUBLESHOOTING TIPS
to the iComfort® S30 by your router, sub-net mask, router, DNS and RSSI. The RSSI signal strength is anywhere between -1 to -69, then the signal strength is sufficient. If outside this range, the either locate the router closer to the thermostat or add a repeater.
Tags:
Information
Domain:
Source:
Link to this page:
Related documents
iComfort S30 Installation and Setup Guide - Lennox
static.lennox.comiComfort Mobile Setup application are available for IOS 6.0 and higher (App Store) and Android 4.1 and higher (Google Play) iHarmony® zoning system (2 - 4 zones), Lennox iComfort® Equipment Interface Module (catalog number 10T50) (connects the iComfort® S30 to non-communicating indoor and outdoor units.
iComfort S30
www.support.lennoxicomfort.com» S30 Smart Hub: 4-1/2 x 4-/2 x 1-1/2” (114 x 114 x 38 mm) - antenna length is 7-1/4” (184 mm) Installation Recommendations WARNING Improper installation, adjustment, alteration, service or maintenance can cause property damage, personal injury or loss of life. Installation and service must be performed by a licensed professional HVAC
EL296V Gas Furnace Brochure - Lennox
resources.lennox.comICOMFORT®-ENABLED Pairs with the iComfort® S30 ultra smart thermostat, so operation is always in sync with your schedule. A variable-speed motor allows the EL296V to constantly adjust airflow speed and gently disperse even heat throughout your home. Because it can fine-tune airflow to match demand, the motor minimizes wasted electricity. It also
iComfort S30 Homeowner Manual - Lennox
resources.lennox.comone iComfort S30 smart thermostat is installed in the home. The iHarmony system can supports zones 2 through 4. Zone 1 is the actual thermostat itself. By default, the zones are labeled Zone 1, Zone 2, Zone 3 and Zone 4. There are also four dots underneath the name that indicates which zone is active on the HOME screen.