CONVECTION STEAM OVEN INSTALLATION GUIDE

1 CONVECTION STEAM OVENINSTALLATION GUIDESPECIFICATIONS, INSTALLATION , AND MORECONVECTION STEAM OVEN2 | Wolf Customer Care CONVECTION STEAM Oven4 Specifications7 Installation7 Troubleshooting Features and specifications are subject to change at any time without notice. Visit for the most up-to-date NoteTo ensure this product is installed and operated as safely and efficiently as possible, take note of the following types of highlighted information throughout this GUIDE :IMPORTANT NOTE highlights information that is especially important. CAUTION indicates a situation where minor injury or product damage may occur if instructions are not states a hazard that may cause serious injury or death if precautions are not followed. IMPORTANT NOTE: Throughout this GUIDE , dimensions in parentheses are millimeters unless otherwise NOTE: Save these instructions for the local electrical , Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design are registered trademarks and service marks of Sub-Zero Group, Inc.

2 And its subsidiaries. All other trademarks are property of their respective owners in the United States and other | 3 CONVECTION STEAM OVENP roduct InformationImportant product information including the model and serial number are listed on the product rating plate. The rating plate is located on the left side of the front face frame. The oven door must be open to view the rating plate. Refer to the illustration service is necessary, contact Wolf Factory Certified Service with the model and serial number. For the name of the nearest Wolf Factory Certified Service or for questions regarding the INSTALLATION , visit the contact & support section of our website, , or call Wolf Customer Care at 800-222-7820. Rating plate location. RATING PLATEI nstallation RequirementsThe CONVECTION STEAM oven can be installed in a standard or flush inset application. The electrical supply for the oven must be located in an adjacent the edges of the opening. They may be visible when the door is standard installations, face trim will overlap stiles and rails.

3 Refer to the flush inset installations, a minimum 1/8" (3) reveal is required on all sides. To ensure consistent reveals, each corner of the opening must be exactly 90 .If the CONVECTION STEAM oven is installed above or below a Wolf E series oven in a flush inset application, a 1/4" (6) reveal is REQUIREMENTSBASE SUPPORTMINC onvection STEAM Oven100 lb (45 kg)TRIM OVERLAP24" MODEL30" MODELTo p3/16" (5)3/16" (5)Bottom0" (0)0" (0)Sides11/16" (18) 37/8" (98)4 | Wolf Customer Care must comply with all applicable electrical the electrical supply as shown in the illustrations on the following pages. A separate circuit servicing only this appliance is required. A ground fault circuit interrupter (GFCI) is not recommended and may cause interruption of operation. Refer to the illustration below for minimum power cord plug may be compromised if the electrical supply is less than 240 REQUIREMENTSE lectrical Supplygrounded, 240/208 VAC, 60 HzService20 amp dedicated circuitReceptacleNEMA 6-20R grounding-typePower Cord6' ( m)SPECIFICATIONS WARNINGELECTRICAL SHOCK HAZARD: Plug into a grounded 3-prong outlet.

4 Do not remove ground prong. Do not use an adapter. Failure to follow these instructions can result in electric shock, fire, or RECEPTACLE3"(76)MINIMUM CORDCLEARANCE NEMA 6-20R receptacle. Power cord clearance. Rating plate location. RATING | 5 SPECIFICATIONSC onvection STEAM OvenSTANDARD INSTALLATIONFRONT VIEWSIDE VIEWNOTE: 24" (610) and 30" (762) models require the same opening supply must be located in adjacent cabinet within 3' (.9 m) of "(449)OPENINGHEIGHT219/16"(548)OPENINGDE PTHTOP VIEWWOPENING WIDTHEEOPENING WIDTHW24" Model221/8" (562)30" Model221/8" (562)6 | Wolf Customer Care STEAM OvenFLUSH INSET INSTALLATIONWFLUSH INSET WIDTH**FRONT VIEWSIDE VIEW23" (584)FLUSH INSETDEPTH7/8" (22)*Will be visible and should be finished to match cabinetry.**Dimension provides minimum : Electrical supply must be located in adjacent cabinet within 3' (.9 m) of "(460) FLUSH INSETHEIGHT**5/16"(8)1/8" (3)ATOP VIEWEEFINISHEDCLEATS*OPENING WIDTHWA24" Model233/4" (603)13/16" (21)30" Model301/8" (765)4" (102) | 7 InstallationPlace the oven in the opening and slide back partially.

5 GUIDE the power cord through the opening of the adjacent cabinet and slide oven back fully. Verify the power cord is not trapped between the oven and cabinet the mounting holes on the oven side trim, two on each side. Drill 1/16" pilot holes. Use the mounting screws provided to secure the oven to the cabinetry. Refer to the illustration avoid interference, a 90 door stop may be required for any appliance or cabinet door installed next to the oven. CAUTIONF ailure to install the mounting screws may cause the oven to tip forward during NOTE: If the CONVECTION STEAM oven does not operate properly, follow these troubleshooting steps: Verify electrical power is supplied to the oven. Verify proper electrical connections. If the oven does not operate properly, contact Wolf Factory Certified Service. Do not attempt to repair the oven. Wolf is not responsible for service required to correct a faulty moving the oven, protect any finished flooring and secure the oven door closed to prevent an appliance dolly to move the unit near the opening.

6 Remove and recycle packing materials. Do not lift or carry the oven by the door handle. OVEN DOOR REMOVALTo remove, open the oven door completely. Rotate both hinge latches forward to the open position. Close the door to the at-rest position, then lift up and out. Refer to the illustrations reinstall, insert the door hinges into the frame open-ings. Open the oven door completely and rotate both hinge latches back to the closed POSITIONCLOSEDPOSITION Oven door hinge latch. Door at-rest Oven INSTALLATION . 2 | Atenci n al cliente de Wolf DE VAPOR DE CONVECCI NContenido3 Horno de vapor de convecci n4 Especificaciones7 Instalaci n7 Resoluci n de problemas Las caracter sticas y especificaciones est n sujetas a cambios sin previo aviso. Visite para obtener la informaci n m s importantePara garantizar que este producto se instale y opere de la forma m s segura y eficiente posible, tome nota de los siguientes tipos de informaci n resaltados en esta gu a:AVISO IMPORTANTE se ala la informaci n que es especialmente importante.

7 PRECAUCI N indica una situaci n en la que se pueden sufrir heridas leves o provocar da os al producto si no se siguen las indica peligro de que se produzcan heridas graves o incluso la muerte si no se siguen las precauciones. AVISO IMPORTANTE: en toda esta gu a, las dimensiones entre par ntesis son mil metros, a menos que se especifique lo IMPORTANTE: guarde estas instrucciones para el inspector el ctrico , Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design son marcas registradas y marcas de servicio de Sub-Zero Group, Inc. y sus asociados. Todas las dem s marcas registradas son propiedad de sus due os respectivos en los Estados Unidos y otros pa ses. | 3 HORNO DE VAPOR DE CONVECCI NInformaci n del productoLa informaci n importante del producto, incluido el modelo y n mero de serie de la unidad, se encuentra en la placa de datos del producto.

8 La placa de datos se encuentra en el lado izquierdo del marco de la cara frontal. La puerta del horno debe estar abierta para ver la placa de datos. Consulte la siguiente ilustraci necesita servicio, p ngase en contacto con el servicio autorizado de Wolf y tenga a mano el modelo y el n mero de serie. Para obtener los datos del centro de servicio autorizado de Wolf m s cercano o si tiene preguntas acerca de la instalaci n, visite la secci n de contacto y soporte t cnico en nuestra p gina de Internet o llame a la l nea de atenci n al cliente de Wolf al 800-222-7820. Ubicaci n de la placa de datos. PLACA DE DATOSR equisitos de instalaci nEl horno de vapor de convecci n se puede instalar en una aplicaci n est ndar o empotrable. Se requiere una base de soporte m nima de 100 libras (45 kg). El suministro el ctrico del horno debe estar ubicado en un gabinete instalaciones est ndares, el ribete frontal se superpondr a los largueros y las gu as. Consulte el cuadro a continuaci n para ver la superposici n de los instalaciones empotrables, requieren un margen m nimo de 1/8" (3) en los cuatro lados.

9 Para asegurar m rgenes consistentes, cada esquina de la abertura debe tener exactamente 90 . D el acabado a los bordes de la abertura. Pueden ser visibles cuando la puerta est el horno de vapor de convecci n se insatala por encima o por debajo de un horno de la Serie E de Wolf en una aplicaci n empotrable, se requiere un margen de 1/4" (6).SUPERPOSICI N DEL RIBETESUPERPOSICI NMODELO DE 24"MODELO DE 30"Parte superior3/16" (5)3/16" (5)Parte inferior0" (0)0" (0)Laterales11/16" (18) 37/8" (98)4 | Atenci n al cliente de Wolf n el ctricaLa instalaci n debe tener una conexi n a tierra de conformidad con los c digos locales o, en ausencia de c digos locales, con el C digo Nacional de Electricidad, ANSI/NFPA 70. Consulte las siguientes suministro el ctrico del horno de vapor de convecci n debe estar en un gabinete adyacente cerca del cable de electricidad de 6 pies (1,8 m). Coloque el suministro el ctrico como se muestra en las ilustraciones de las p ginas 5-6. Es necesario un circuito independiente que d servicio nicamente a este aparato.

10 No es recomendable utilizar un circuito de fallos de conexi n a tierra (GFCI, por sus siglas en ingl s) ya que puede interrumpir el funcionamiento de la rendimiento puede verse comprometido si el suministro el ctrico es menor a 240 EL CTRICOSS uministro el ctricoCon conexi n a tierra, 240/208 V CA, 60 HzServicioCircuito dedicado de 20 amperesRecept culoTipo de conexi n a tierra NEMA 6-20 RCable de alimentaci n el ctrica6' (1,8 m) ADVERTENCIAPELIGRO DE DESCARGA EL CTRICA: enchufe en enchufe de 3 patas con conexi n a tierra. No retire la clavija de conexi n a tierra. No use un adaptador. No cumplir con estas instrucciones puede producir una descarga el ctrica, fuego o Ubicaci n de la placa de datos. PLACA DE DATOSNEMAPLUGGROUNDEDNEMA RECEPTACLE3"(76)NEMAPLUGMINIMUM CORDCLEARANCE Recept culo NEMA 6-20R. Espacio libre para el NEMARECEPT CULO NEMA CON CONEXI N A TIERRAESPACIO LIBRE M NIMO PARA EL | 5 VISTA FRONTALVISTA LATERALNOTA: los modelos de 24" (610) y 30" (762) requieren las mismas dimensiones de suministro el ctrico debe estar en un gabinete adyacente a 3 pies (0,9 m) de la "(449) ALTURA DE LAABERTURA219/16"(548)PROFUNDIDAD DE LAABERTURAVISTA SUPERIORWANCHO DE ABERTURAEEESPECIFICACIONESH orno de vapor de convecci nINSTALACI N EST NDARANCHO DE ABERTURAANCHO (W)Modelo de 24"221/8" (562)Modelo de 30"221/8" (562)6 | Atenci n al cliente de Wolf de vapor de convecci nINSTALACI N EMPOTRABLEANCHO DE ABERTURAANCHO (W)AModelo de 24"233/4" (603)13/16" (21)Modelo de 30"301/8" (765)4" (102)WANCHO DE LAINSTALACI N EMPOTRABLE**FRONT VIEWVISTA LATERAL23" (584)PROFUNDIDADDE LAINSTALACI NEMPOTRABLE7/8" (22)*Ser visible y debe tener un acabado que haga juego con los gabinetes.