Transcription of CS-5700 - Shimano
1 CassettesprocketSprockets marked by are toothconfiguration11T - 25T12T - 25T12T - 27T11T, 12T, 13T, 14T, 15T, 17T, 19T, 21T, 23T, 25T12T, 13T, 14T, 15T, 16T, 17T, 19T, 21T, 23T, 25T12T, 13T, 14T, 15T, 16T, 17T, 19T, 21T, 24T, 27 TGeneral Safety InformationWARNING Check that the wheels are fastened securely before riding the the wheels are loose in any way, they may come off the bicycle andserious injury may result. Obtain and read the service instructions carefully prior to installingthe , worn or damaged parts may cause the bicycle tofall over and serious injury may occur as a result. We stronglyrecommend only using genuine Shimano replacement parts. Read these Technical Service Instructions carefully, and keep them ina safe place for later Do not use the CS-5700 in any combination other than with the 10-speed super narrow chain.
2 Other chains cannot be used as the sizesdo not match. An 11T and a 12T lock ring are available for use with the whichever lock ring matches the sprocket configuration. You should periodically wash the sprockets in a neutral detergent andthen lubricate them again. In addition, cleaning the chain with neutraldetergent and lubricating it can be a effective way of extending theuseful life of the sprockets and the chain. If the chain keeps coming off the sprockets during use, replace thesprockets and the chain. Parts are not guaranteed against natural wear or deteriorationresulting from normal use. For maximum performance we highly recommend Shimano lubricantsand maintenance of spoke holesOverlock nut dimensionsFH-57008 / 9 / 1032 / 36130 mmFreehubCS-5700 Model - 28T11T, 12T, 13T, 14T, 15T, 17T, 19T, 21T, 24T, 28 TSI-1YN0A-001-00 One Holland, Irvine, California 92618, Phone: +1-949-951-5003 Industrieweg 24, 8071 CT Nunspeet, The Netherlands Phone: +31-341-2722223-77 Oimatsu-cho, Sakai-ku, Sakai-shi, Osaka 590-8577, Japan* Service Instructions in further languages are available at : note: specifications are subject to change for improvement without notice.
3 (English) Nov. 2009 by Shimano Inc. XBC IZM Printed in - 25T, 11T - 28 TSprocket spacersSpacerLock ringLock ring spacer12T - 25T, 12T - 27 TSprocket spacersSpacerLock ringLock ring spacerInstallation of the HG sprocketsFor each sprocket, thesurface that has the groupmark should face outwardand be positioned so that thewide parts of the gearprojections on each sprocketand the A part (where thegroove width is wide) of thefreewheel body are aligned. For installation of the HG sprockets, use the special tool (TL-LR15)to tighten the lock ring. To replace the HG sprockets, use the special tool (TL-LR15) andTL-SR21 to remove the lock groove is wide atone place partTightening torque: 30 - 50 N m {261 - 434 in. lbs.}Lock ringTool (TL-SR21)DisassemblyTL-LR15 Technical Service InstructionsSI-1YN0A-001CS-5700 Cassette sprocket
