Example: biology

CSR/CSRN Series Stackpole Electronics, Inc.

Rev Date: 03/23/2020 1 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Features: 0201 to 1225 sizes available Power ratings to 3W Low inductance less than typically Non-standard resistance values available 0815, 2010 and 2512 sizes available with narrow terminations (CSRN) RoHS compliant and halogen free REACH compliant Electrical Specifications - CSR Electrical Specifications CSR-HP Electrical Specifications CSRN (Narrow Termination) 1%, 2%, 5%CSRN20101200 - 1 - - (*)2200 - 1(*) AEC-Q200 QualifiedCSRN08151200 Type / CodePower Rating (W) @ 70 C Dielectric Withstanding Voltage (V)TCR (ppm/ C)Ohmic Range ( ) and Tolerance1%2%, 5% 1000 600 300 100 (1) 600 400 300 200 CSR20101200 100 (1)CSR25122200 200 - 200 150 300 200 150 - - - - - - - - 1 TCR (ppm/ C)

Rev Date: 06/28/2018 www.seielect.com This specification may be changed at any time without prior notice [email protected] CSR/CSRN Series . Stackpole Electronics, Inc.

Tags:

  Electronic, Stackpole electronics, Stackpole

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of CSR/CSRN Series Stackpole Electronics, Inc.

1 Rev Date: 03/23/2020 1 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Features: 0201 to 1225 sizes available Power ratings to 3W Low inductance less than typically Non-standard resistance values available 0815, 2010 and 2512 sizes available with narrow terminations (CSRN) RoHS compliant and halogen free REACH compliant Electrical Specifications - CSR Electrical Specifications CSR-HP Electrical Specifications CSRN (Narrow Termination) 1%, 2%, 5%CSRN20101200 - 1 - - (*)2200 - 1(*) AEC-Q200 QualifiedCSRN08151200 Type / CodePower Rating (W) @ 70 C Dielectric Withstanding Voltage (V)TCR (ppm/ C)Ohmic Range ( ) and Tolerance1%2%, 5% 1000 600 300 100 (1) 600 400 300 200 CSR20101200 100 (1)CSR25122200 200 - 200 150 300 200 150 - - - - - - - - 1 TCR (ppm/ C)

2 Type / CodeDielectric Withstanding Voltage (V) - - - - - - 1 Ohmic Range ( ) and TolerancePower Rating (W) @ 70 C - - - - - (1) Contact Stackpole for TCR below 50 mohmCSR08301%, 2%, 5% - - - / CodePower Rating (W) @ 70 C Dielectric Withstanding Voltage (V)TCR (ppm/ C)Ohmic Range ( ) and Tolerance Rev Date: 03/23/2020 2 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Please refer to the High-Power Resistor Application Note (page 7) for more information on designing and implementing high power resistor types. Mechanical Specifications Mechanical Specifications CSRN (Narrow Termination) Weight (g)(1000 pieces) / CodeUnitLBody LengthWBody WidthTBody HeightBottom (g)(1000 pieces) TerminationType / CodeLWTD1D2 UnitBody LengthBody WidthCSRN2512 CSRN0815 CSRN2010 Body HeightTop Specifications CSR-HP (cont.)

3 1%, 2%, 5% - - - - 1 TCR (ppm/ C)Ohmic Range ( ) and / CodePower Rating (W) @ 70 C Dielectric Withstanding Voltage (V) Rev Date: 03/23/2020 3 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Mechanical Specifications CSR1225 Weight (g)(1000 pieces) / CodeWPerformance Characteristics TestTest MethodTest SpecificationTypicalTest ConditionHigh Temperature ExposureMIL-STD-202 Method 1081% Tol: ( 1% + ) 2%, 5% Tol: ( + ) hours at T = 155 C. Unpowered. Measurement at 24 4 hours after test conclusion. ( + ) (1% + ) For high power rating CyclingJESD22 Method JA-1041% Tol: ( + ) 2%, 5% Tol: ( + ) Cycles (-55 C to +125 C) Measurement at 24 4 hours after test conclusion.

4 30 minuntes maximum dwell time at each temperature extreme. 1 minute maximum transition HumidityMIL-STD-202 Method 1031% Tol: ( 1% + ) 2%, 5% Tol: ( 2% + ) hours 85 C / 85% RH. Note: Specified conditions: 10% of operating power. Measurement at 24 4 hours after test LifeMIL-STD-202 Method 1081% Tol: ( 1% + ) 2%, 5% Tol: ( 2% + ) D Steady State TA = 125 C at rated power. Measurement at 24 4 hours after test VisualMIL-STD 883 Method 2009-PassElectrical test not required. Inspect device construction, marking and DimensionsJESD22 Method JB-100-PassVerify physical dimensions to the applicable device detail specification. Note: User(s) and supplier specification, electrical test not to SolventsMIL-STD 202 Method 215 Marking unsmearedPassNote: Aqueous wash chemical - OKEM Clean or equivalent.

5 Do not use banned ShockMIL-STD 202 Method 2131% Tol: ( + ) 2%, 5% Tol: ( 1% + ) 1 of Method 213. Condition 202 Method 2041% Tol: ( + ) 2%, 5% Tol: ( 1% + ) 's for 20 minuntes, 12 cycles each of 3 orientations. Note: Use 8" X 5" PCB " thick 7 secure points on one long side and 2 secure points at corners of opposite sides. Parts mounted within 2" from any secure point. Test from 10 - to Soldering HeatMIL-STD 202 Method 2101% Tol: ( + ) 2%, 5% Tol: ( 1% + ) B no pre-heat of samples. Note: Single wave solder - Procedure 2 for the electrometer in direct contact with the discharge tip, verify the voltage setting at levels of 500V, 1kV, 2kV, 4kV, 8kV. The electrometer reading shall be within 10% for voltages from 500V to > 95% CoveragePassElectrical test not required.

6 Magnification 50 times. Conditions: SMD: a) Method B, 4 hours @ 155 C dry heat @ 235 C. b) Method B @ 215 C category 3. c) Method D category 3 at 260 C. Short Time OverloadJIS-C-5201-1 IEC 60115-1 (rated current) * for 5 seconds. Rev Date: 03/23/2020 4 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Power Derating Curve: Recommended Pad Layouts - CSR Performance Characteristics (cont.

7 TestTest MethodTest SpecificationTypicalTest ConditionElectrical CharacterizationUser Spec--PassParametrically test per lot and sample size requirements, summary to show Min, Max, Mean and Standard Deviation at room as well as Min and Max operating ignition of tissue or scorching of pine - 0 or V - 1 are acceptable. Electrical test not FlexAEC-Q200-0051% Tol: ( 1% + ) 2%, 5% Tol: ( 1% + ) second minimum holding times Max. Operating Voltage for 1 temperature range is -55 C to +155 CTerminal Strength (SMD)AEC-Q200-006 Flame RetardanceAEC-Q200-001No breakagePassNo flamePassVoltage ProofJIS-C-5201-1 IEC-60115-1 breakdown or flashoverPass0201: 50V; 0402: 100V; 0603: 150V; 0805: 300V1206, 1210, 2010, 2512, 0830, 1225, 0815: 400V0 Percent Rated Power (%)100-55 C70 C806040202040155 C-600 Ambient Temperature ( C)1201401601806080100 Type / Rev Date: 03/23/2020 5 This specification may be changed at any time without prior notice.

8 Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Recommended Pad Layouts - CSRN Reel Specifications Type / Pad Layouts CSR (cont.) Type / / Rev Date: 03/23/2020 6 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions Packaging Specifications Paper Tape Packaging Specifications Embossed Plastic Tape + + Rev Date: 03/23/2020 7 This specification may be changed at any time without prior notice.

9 Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions High Power Chip Resistors and Thermal Management Stackpole has developed several surface mount resistor Series in addition to our current sense resistors, which have had higher power ratings than standard resistor chips. This has caused some uncertainty and even confusion by users as to how to reliably use these resistors at the higher power ratings in their designs. The data sheets for the RHC, RMCP, RNCP, CSR, CSRN, CSRF, CSS, and CSSH state that the rated power assumes an ambient temperature of no more than 100 C for the CSS / CSSH Series and 70 C for all other high power resistor Series . In addition, IPC and UL best practices dictate that the combined temperature on any resistor due to power dissipated and ambient air shall be no more than 105 C.

10 At first glance this wouldn t seem too difficult, however the graph below shows typical heat rise for the CSR1206 100 milliohms at full rated power. The heat rise for the RMCP and RNCP would be similar. The RHC with its unique materials, design, and processes would have less heat rise and therefore would be easier to implement for any given customer. Packaging Specifications Embossed Plastic Tape (cont.) + + , + + , + + , mm122508150830P1P2D0T20102512P0 Rev Date: 03/23/2020 8 This specification may be changed at any time without prior notice. Please confirm technical specifications before you order and/or use. CSR / CSRN Series Thick Film Current Sensing Resistor Stackpole Electronics, Inc. Resistive Product Solutions CSRT hick Film Current Sensing Surface Mount Chip ResistorSMDYES by means of exemption 7c-I100% Matte Sn over NiMay-0404/18 CSRNT hick Film Current Sensing Surface Mount Chip Resistor, NarrowSMDYES by means of exemption 7c-I100% Matte Sn over NiMay-0404/18 Lead-Free Effective Date Code (YY/WW)Standard Product SeriesDescriptionPackage / Termination TypeStandard Series RoHS CompliantLead-Free Termination CompositionLead-Free Mfg.


Related search queries