ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

1 1 ELECTRIC wall oven INSTALLATION INSTRUCTIONS **Door Open(see note)SpacerABCDHFG2" ( ) Wide Wood Spacer if NeededHole for cable and electrical junction box on right side for 24" Wall " ( ) Junction Box (Right or left side depending of model)2" ( ) AND SERVICE MUST BE PERFORMED BY A QUALIFIED : SAVE FOR LOCAL electrical INSPECTOR'S AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE. FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other new wall oven has been designed to fit a limited variety of cutout sizes to make the job of installing easier.

2 The first step of your INSTALLATION should be to measure your current cutout dimensions and compare them to the cutout dimensions chart below or next page for your model. You may find little or no cabinet work will be 124" AND 30" SINGLE ovens (Double ovens see Figure 2) P/N 318201509 (1001) Rev. FEnglish pages 1-8 Espa ol p ginas 9-16 Fran ais pages 17-24 Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or models are not available in NOT INSTALL A 24" wall oven IN A BASE CABINET WITH A COUNTERTOP ABOVE : Dimension G is critical to the proper INSTALLATION of the built-in oven.

3 If the oven decorative trim (ventilation) does not but against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is according to the required dimension. All dimensions are in inches (cm).NOTE: For a cutout height greater than H Min. dimension add one 2" (5cm) wide wood shim to each side of the opening under the appliance side : Base must be capable of supporting 150 pounds (68 kg). ** NOTE: Allow at least 19 3/8" ( ) clearance for door depth when it is open.* 24" models: Required distance from floor is 31" ( ). 30" models: Suggested distance from floor is 31" ( ).

4 Minimum required distance is 4 " ( ).28 3/32" ( )31"* ( )Hole for cable and electrical junction box on left side for 30" Wall 1/2" ( ) in United StatesCanadaUnited StatesPRODUCT DIMENSIONSMODELABC (wrapper)D24" (61 cm) Wall Oven23 7/8 ( )30 3/4 ( )21 11/16 ( )25 3/8 ( )30" ( cm) Wall Oven29 7/8 ( )29 7/8 ( )28 3/8 ( )25 3/8 ( )CUTOUT DIMENSIONS AND CABINET WIDTHMODELFG (Min.) " (61 cm) Wall Oven22 ( )22 1/4 ( )23 1/2 ( )28 1/8 ( )30 1/8 ( )24 (61) Min30" ( cm) Wall Oven28 ( )29 ( )24 (61)28 1/4 ( )28 7/8 ( )30 ( ) Min2 ELECTRIC wall oven INSTALLATION INSTRUCTIONSF igure 227" AND 30" DOUBLE ovens (Single ovens see Figure 1)Some models are not available in Canada.

5 Do not remove spacers (if equipped) on the side walls and/or on the back of the built-in oven. These spacers center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result in heat damage or : Dimension G is critical to the proper INSTALLATION of the built-in oven. If the oven decorative trim (ventilation) does not but against the cabinet, or if noise is heard on convection models, verify dimension G to assure it is according to the required dimension. All dimensions are in inches (cm).NOTE: Base must be capable of supporting 300 pounds (136 kg).** NOTE: Allow at least 19 3/8" ( ) clearance for door depth when it is open.

6 * Dimensions for stainless steel " ( ) 1/2" ( ) 1/2" ( )GFH47 3/4" ( )** Door Open(see note)2" ( ) for cable and electrical junction box on left side for 30" Wall Junction Box(Right or left side depending of model)Hole for cable and electrical junction box on right side for 27" Wall DIMENSIONSMODELABC (wrapper)D27" ( cm) Wall Oven26 7/8 ( ) (27 1/8 ( ))49 ( )24 11/16 ( )25 3/8 ( )30" ( cm) Wall Oven29 7/8 ( )50 (127)28 3/8 ( )25 7/16 ( )CUTOUT DIMENSIONS AND CABINET WIDTHMODELFG (Min.) " ( cm) Wall Oven24 7/8 ( )25 ( )23 ( )48 ( )49 7/8 ( )27 ( ) Min30" ( cm) Wall Oven28 ( )29 ( )24 (61)49 1/8 ( )49 ( )30 ( ) Min3 ELECTRIC wall oven INSTALLATION INSTRUCTIONSI mportant Notes to the Installer1.

7 Read all INSTRUCTIONS contained in these INSTALLATION INSTRUCTIONS before installing the wall Remove all packing material from the oven compartments before connecting the electrical supply to the wall Observe all governing codes and Be sure to leave these INSTRUCTIONS with the Oven door may be removed to facilitate THESE ovens ARE NOT APPROVED FOR STACKABLE OR SIDE-BY-SIDE Note to the ConsumerKeep these INSTRUCTIONS with your Owner's Guide for future SAFETY INSTRUCTIONS Be sure your wall oven is installed and grounded properly by a qualified installer or service technician. This wall oven must be electrically grounded in accordance with local codes or, in their absence, with the National electrical code ansi /NFPA latest edition in United States, or with CSA Standard , Canadian electrical code , Part 1, in Canada.

8 Stepping, leaning or sitting on the door of this wall oven can result in serious injuries and can also cause damage to the wall oven . Never use your wall oven for warming or heating the room. Prolonged use of the wall oven without adequate ventilation can be dangerous. The electrical power to the oven must be shut off while line connections are being made. Failure to do so could result in serious injury or CarpentryRefer to figure 1 or 2 for the dimensions applicable to your appliance, and the space necessary to receive the oven. The oven support surface may be solid plywood or similar material, however the surface must be level from side to side and front to electrical RequirementsThis appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or fuse.

9 To know the circuit breaker or fuse required by your model, see the serial plate to find the wattage consumption and refer to table A to get the circuit breaker or fuse all governing codes and local ordinances1. A 3-wire or 4-wire single phase 120/240 or 120/208 Volt, 60 Hz AC only electrical supply is required on a separate circuit fused on both sides of the line (red and black wires). A time-delay fuse or circuit breaker is recommended. DO NOT fuse neutral (white wire). Only certain cooktop models may be installed over certain built-in ELECTRIC oven models. Approved cooktops and built-in ovens are listed by the MFG ID number (see the insert sheet included in the literature package).

10 NOTE: Wire sizes and connections must conform with the fuse size and rating of the appliance in accordance with the American National electrical code ansi /NFPA No. 70-latest edition, or with Canadian CSA Standard , Canadian electrical code , Part 1, and local codes and ordinances. An extension cord should not be used with this appliance. Such use may result in a fire, electrical shock, or other personal injury. If you need a longer power cord you can purchase a 10' (3 m) power cord kit #903056-9010 by calling the Service These appliances should be connected to the fused disconnect (or circuit breaker) box through flexible armored or nonmetallic sheathed cable.