English assembly instruction PI rimless

1 1 assembly InstructionsRimless Perf. Inserta708/a714/a515 (3 )a723/a715/a516 (3 )2In case of long eyelashes we recommend the use of the extended version (higher nose piece).3 assembly InstructionsOptical aberrations can occur with wrap-around eyewear and as a result of the tilted position of the lenses in the affects Perf. Insert lenses and direct-inframe glazing in wrap-around sport eyewear and best possible correction we recommed the use of thesilhouette wrap-around calculator( ). Please contact your InstructionsFor all details regarding theexact and comfortablecapture of the lens data, please refer to the CD in theseparately available adidasassembly box!51. Preparation of assembly holesPrint out the drilling coordinates 1:16 Grind the lenses 1:1 and mark thelens axis on optical glass with a waterproof glass edges as Preparation assembly holes7 Mark all drilling positions and auxiliary markings on the front of the lenses using the coordinatedrawing.

2 1. Preparation assembly holes81. Preparation assembly holesCheck that the markings match exactly and are at thesame level on both sides. We recommend placing thelenses on chequered milimetre paper as a background. 9 Protect the front side of the lensesand the markings for the drillingtemplate with conventionaltransparent adhesive Preparation assembly holes10 Attach double-sided adhesive tapeto the drilling do this place the centre point of the drilling template on the nasal marking and on the front side of the lens and align it with theauxiliary line. 1. Preparation assembly holes11 Place the corrective lens onto a backing board. Drill the holes at 90 to the front side of the diameter = 2 mm2. Drill holes12 Drill a blind hole in the drillingposition marked on the front sideof the diameter = mm2. Drill holes for rubber damping pads13 IMPORTANT:Proper cleaning and deburring of the holes on the front and back of the lenses and the blind hole!

3 2. Drill holes14 Cut off approx. 3 cm of the rubberthread provided in the assemblybox, immerse it in instant adhesiveand insert it into the blind hole. We recommend the use of theinstant adhesive Loctite 406 .3. Attachment of the damping pad on the earpiece side15 Allow the instant adhesive to dry, then cut off approx. mm abovethe lense with a sharp knife, edgecutters or a pair of greenSilhouette disconnecting pliers. 3. Attachment of the damping pad on the earpiece side16 Push the plastic sleeves (BLS 63) through the holes in the lens fromthe back and cut off according to the thickness of the remove the conventionaladhesive tape!4. Assembly17 Clean the lens and press theframe element fully into theplastic sleeves using theassembly pliers (red cheek).Place the adjustable cheek of thepliers onto the head of theplastic sleeves (BLS 63).4. Assembly18 Attach the protective film (conventional adhesive tape) to therear side of the lens near the BLS.

4 Pull out the BLS from theback using the green Silhouette disassembly pliers. Removethe protective film. BE CAREFUL NOT to damage the barbed hooks!5. DisassemblyBLS disassembly pliers P0004