Example: barber
GAS PRESSURE REGULATORS CATALOG - Maxitrol
include residential, commercial, and industrial gas-fired appliances and ... RV61 are suitable for multi-positional mounting. RV81, RV91, RV111, RV131, mount in an upright position only. If a ® or ® is installed, mount in an upright position only. The ® 12A06 is multi-positional. NOTE: All Maxitrol gas pressure regulators should be installed ...
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Gas Pressure - Maxitrol
www.maxitrol.com© 2011, Maxitrol Company. All Rights Reserved. 1 Gas Pressure Regulators Catalog For Industrial Engines and Generator Sets
This Handbook contains information from national …
www.maxitrol.com6 Figure 1: 325-3L with 12A09 ® Vent Limiting Device LINE PRESSURE REGULATORS ANSI Z21.80/CSA 6.22 is the standard for line pressure regulators,
GAS PRESSURE REGULATORS CATALOG
www.maxitrol.comWhen sizing a regulator the following must be known: • Gas Type • Available Inlet Pressure • Desired Outlet Pressure • Zero Governor Application (indicated by model number ending in “Z”) • Will the regulator control main burner and pilot load OR main burner only? • 3Required minimum and maximum flow rate in cfh or m/h or Btu/h
GAS PRESSURE REGULATORS CATALOG - Maxitrol
www.maxitrol.com• Solution: The RV48 (1/2”) has a maximum capacity of 230,000 Bth/h and a maximum individual load of 160,000 Btu/h. The pressure drop at a flow rate of 150,000 Btu/h is 0.4” w.c., well below the available differential of 3” w.c. The RV48 (without “L” fixed orifice) is the correct regulator to use for the application.
Related documents
HS26-060-1P GCS16-090-350-2Y - Lennox
www.lennox.comOn residential gas and oil furnaces this identification plate is ... G**M Gas furnace multi position G**MP Gas furnace multi position G**V Gas furnace variable speed ... Gas fired rooftop systems (heating, make-up air, ventilating) LUF Oil fired unit heater
General Guidance on the selection and installation of ...
www.hetas.co.ukmulti fuel appliances in residential properties. ... number are specifically designed for use with gas fired appliances. These must not be used with wood burning or multi fuel appliances. Clay and pumice chimney systems and liners are suitable for wood, multi fuel, oil and ... Chimney Position The ideal location for a chimney is on the inside ...
INSTALLATION MANUAL
yorkwest.net1. Only Natural gas or Propane (LP) gas are approved for use with this furnace. 2. Install this furnace only in a location and position as specified in these instructions. 3. A gas-fired furnace for installation in a residential garage must be installed as specified in these instructions. 4. Provide adequate combustion and ventilation air to ...
Return Air Duct System
www.unicosystem.com2. Avoid creating a negative pressure zone near gas-fired equipment. As an example, do not put a return near a boiler or gas water heater. If the equipment is installed in a basement with a closed door, be sure to install a return for the first floor. 3. It is best to position the return high, near the ceiling,