Example: marketing
Glulam Product Guide - American Laminators
standard for glulam was Commercial Standard CS253-63, which was published by the ... includes a second set of designations. For example, for an unbalanced 24F layup using visually graded Douglas-fir lumber, the layup designation is identified as a 24F-V4. ... manufactured in commonly used dimensions and cut to length when the beams are ordered ...
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Technical Note: Glulam Beam Camber - American …
americanlaminators.comT E C H N I C A L N O T E Glulam Beam Camber August 2011 One of the most important design qualities of wood framing is its resilience under load.
Related documents
Standard Specifications for Wood Poles
www.fpl.fs.fed.usSTANDARD SPECIFICATIONS FOR WOOD POLES Ronald Wolfe, Research General Engineer ... dimensions, and fiber stress values for design. The special emphasis on the role of the ANSI 05.1 wood ... Douglas-fir, and oak. Thirty years later, ASTM adopted standard The ANSI 05.1 standard covers the specifications and
Standard Dimensions for Furniture Design
www.cawspi.orgDouglas Fir Hard Maple (Sugar) White Oak White Ash Shortleaf Pine alack Walnut Yellow Poplar alack Cherry Red Oak White Fir Ponderosa Pine White Pine Western Red Cedar Modulus of Elasticity (E) 2 .01 1.95 1.83 1.78 1.77 ... Standard Standing Height: Dimensions of Bookcases and Shelves Bookcase 30" 8" 24" 30" 36" 6" 24" 72" 30" 36" 10" 36" 84 ...
Installation Manual
downloads.hearthnhome.com*Weighted average LHV efficiencyusing Douglas Fir dimensional lumber and data collected during EPA emissions test. **Weighted average HHV efficiencyusing Douglas Fir dimensional lumber and data collected during EPA emissions test. ***Efficienciesare based on test results calculated using B415; these calculated efficienciesare then used to
Installation Manual
downloads.hearthnhome.comSTANDARD(s): ASTM E2515, ASTM E2780, UL 1482-2011 (2015), ULC-S627-00, CSA B415.1 Fire Risk. Hearth & Home Technologies disclaims any responsibility for, and the warranty will be voided by, the following actions:! WARNING • Installation and use of any damaged appliance. • Modification of the appliance.
CROSS-LAMINATED TIMBER - BRE
www.bre.co.ukfir, silver fir, Douglas fir, pine or other timbers. While C24-grade timber is often used, there has been an increase in the use of C16 timber. As the latter is more readily available in the UK, manufacture of CLT panels may become more feasible in future; at the time of writing, all panels are imported (eg from Germany, Austria and Switzerland).
Contents
www.huberwood.comThe OSB substrate complies with Voluntary Product Standard PS2 for wood structural panels and the water-resistive barrier complies as an alternate to the water-resistive barrier prescribed in the code. ZIP System® R-Sheathing is available with a 1/2-inch, 1-inch, 1-1/2-inch and 2-inch foam insulation panel. clearance between ZIP System R. less ...