Example: tourism industry
Hazard identification checklist
HAZARD IDENTIFICATION CHECKLIST Hazard identification Checklist Page 1 of 2 V3 – April 2012 ... A risk assessment and entry permit must be prepared by a competent person before entry ... and even step dimensions Ramps should be no more than 1:8 or 1:14 for disabled access, slip resistant ...
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Emergency planning for ammonia-based refrigeration …
www.worksafe.qld.gov.auprepare an effective emergency plan for workplaces with anhydrous ammonia-based refrigeration systems. The guide includes information on the unique hazards presented by ammonia gas and its use in refrigeration, and relevant duties that apply under the work health and safety (WHS) legislation.
A guide for flammable and combustible liquids
www.worksafe.qld.gov.auA licence to store flammable and combustible liquids is not required under the WHS Regulation. The safe storage and handling of flammable and combustible liquids is covered by the safety duties for hazardous chemicals under the WHS Regulation, administered and enforced within Queensland by Workplace Health and Safety Queensland (WHSQ).
Guide to machinery and equipment safety
www.worksafe.qld.gov.au• machinery and equipment with moving parts that can reach people, such as booms or mechanical appendages (arms) • mobile machinery and equipment, such as forklifts, pallet jacks, earthmoving equipment, operated in areas where people may gain access. Common mechanical hazards and associated risks for machinery and equipment are shown below.
Code of Practice 2018 - worksafe.qld.gov.au
www.worksafe.qld.gov.auThis Code of Practice on how to manage the risk of falls in the workplace is an approved code of practice under section 274 of the Work Health and Safety Act 2011 (the WHS Act). An approved code of practice is a practical guide to achieving the standards of health, safety
How to Manage Work Health and Safety Risks Code of ...
www.worksafe.qld.gov.auHow to manage work health and safety risks Code of practice 2011 (PN11157) page 4 of 27 Foreword The How to manage work health and safety risks Code of Practice is an approved code of practice under section 274 of the Work Health and Safety Act 2011 (the WHS Act). An approved code of practice is a practical guide to achieving the standards of health, safety and
Formwork Code of Practice 2016 - WorkSafe Queensland
www.worksafe.qld.gov.auFormwork Code of Practice 2016 (PN11965)Page 5 of 54 Foreword This Formwork Code of Practice 2016 is an approved code of practice under section 274 of the Work Health and Safety Act 2011 (the WHS Act). An approved code of practice is a practical guide …
Silica - Identifying and managing crystalline silica dust ...
www.worksafe.qld.gov.auThe exposure standard for respirable crystalline silica The National Workplace Exposure Standard for crystalline silica of 0.05 mg/m 3 pertaining to dusts containing quartz, cristobalite or trydimite, measured as respirable dust. The sampling protocol to be used is that contained in Australian Standard 2985 – 2009 Workplace Atmospheres - Method
Shifting nutrition - a shift workers guide to nutrition
www.worksafe.qld.gov.auwhat you eat - helping you to shift your nutrition and ensure you are eating the right foods, at the right time. What happens to your body when you work shifts? Your body has a 24 hour cycle (also known as your body clock) that helps to regulate when you wake-up, your digestion, hormones and many other functions of your body.
Workplace Rehabilitation Policy and Procedures for
www.worksafe.qld.gov.auRehabilitation may involve receiving treatment from a registered person (eg physiotherapist, podiatrist, dentist) or aids or equipment approved by WorkCover. Rehabilitation and Return to Work Coordinator (RRTWC) The RRTWC is a person who has completed a workplace rehabilitation course approved by Q-COMP. The RRTWC is the link
Related documents
Comprehensive OSHA Hazard Assessment Checklist
www.monitorqa.comComprehensive OSHA Hazard Assessment Checklist General Workplace General Work Environment Are all worksites clean and orderly? ... Are step risers on stairs uniform from top to bottom, with no riser spacing ... Yes No N/A Do stairway handrails have a least 1-1/2 inches of clearance between the handrails and the wall or surface they are mounted ...
Pennsylvania Hazard Mitigation Plan Standard Operating …
www.pema.pa.govStep 4: Summarize Repetitive Loss Properties (Flood Hazard Only). 1) Table Summarizing number and structure type of RL and SRL properties in each community. Step 5: Establish Probability of Future Occurrence. 1) Assessment of future hazard probability. Step 6: Determine Environmental Impacts. 1) List or discussion of potential environmental ...
COVID-19 Healthcare Worksite Checklist & Employee Job ...
www.osha.govSTEP 2: If the ETS applies to your workplace or portions of your workplace, use this Worksite Checklist & Employee Job Hazard Analysis to develop and implement worker protections from COVID-19 in your workplace. Use the sections of this Worksite Checklist & Employee Job Hazard Analysis that apply to your workplace or portions
PLANT & EQUIPMENT RISK ASSESSMENT CHECKLIST
safetyrisk.net1.2 OHS Responsibilities 1.3 Information, Instruction, Training, Induction, Supervision 2.10 Noise Part 3 Plant (including) 3.2.25 Plant with moving parts 3.2.15 Hazard Management 3.2.17 Control of risk AS 4024 - 2006 Safety of machinery AS 60204.1 electrical equipment for industrial machines RISK ASSESSMENT TEAM
Job Hazard Analysis - Occupational Safety and Health ...
www.osha.govThe examples that follow show how a job hazard analysis can be used to identify the existing or potential hazards for each basic step involved in grinding iron castings. Grinding Iron Castings: Job Steps Step 1. Reach into metal box to right of machine, grasp casting, and carry to wheel. Step 2. Push casting against wheel to grind off burr. Step 3.
Check for Safety: A Home Fall Prevention Checklist for ...
www.cdc.govThe checklist asks about hazards . found in each room of your home. For each hazard, the checklist tells you how to fix the problem. At the end of the checklist, you’ll find other tips for preventing falls. “Making changes in our home to prevent falls is . good for us and for our granddaughter when she comes to visit.” Check for. Safety ...
Step 1: Identify the hazards - RoSPA
www.rospa.comThe Health and Safety Executive’s Five steps to risk assessment Step 1: Identify the hazards Walk around your venue and look at what could reasonably be expected to cause harm. Ask your other people what they think. They may have noticed things that are not immediately obvious to you. Visit the HSE website. HSE publishes practical guidance on ...