INSTALLATION INSTRUCTIONS WALL HUNG …

1 Thank you for selecting the Crane Plumbing wall hung urinal. To insure this product is installed properly, pleaseread these INSTRUCTIONS carefully before you begin. This high quality, vitreous china fixture is meant to provide manyyears of service, but can be damaged by improper handling and/or INSTALLATION . Be sure your INSTALLATION conformsto local INSTRUCTIONSWALL hung URINALSU npack the a moment to check thefixture to make sure there is no damage. Verify thatyou have all the necessary tools, fittings, andconnection hardware to complete the INSTALLATION3 FinishedFloorHangerLocationsC-L of 2 x 6 Support(If Needed)A urinal is heavy.

2 Provide suitable structural supportbehind the finished wall for the lag wall, or whatever material the screws areattached to, must be of sufficient strength to fullysupport the urinal is attached to the wall at the top withhangers that are screwed to the wall. The bottom isattached with lag screws through the slots in thechina, through the holes in the outlet connection,into the finished may be necessary to install a 2 x 6 boards behindthe finished wall. Position the boards between twostuds so the front surface of the board is flush withthe front of the studs. The finished wall is then appliedover the boards.

3 (See Figure 1).INSTALLATIONF igure 1 Dimension fromfloor to C-L ofhanger screwsModelA49929-1/2 Refer to the chart at right, with Figure 2 to determinethe placement of the outlet, hangers, and mountingscrews. Rim height above the floor is typically 24 Maximum for standard INSTALLATION , and 17 A is the centerline location of the primaryhanger mounting screws. Dimension B is thecenterline of the hanger screws to the top of the C is from the top of the rim, to thecenterline of the outlet. Dimension D is the centerlinelocation of the bottom mounting screws.(Note that Models 4992 and 7121 only use onehanger on the centerline of the 7 71044-1/2 7 2-1/2 7 *712110 4-5/8 5-1/2 C/L716011-1/8 6-3/4 5-1/2 10 716111-1/8 6-3/4 5-1/2 10 716715-5/8 3-1/2 5-1/2 10 716818-1/2 6-3/4 5-1/2 10 719015-3/8 2-1/8 5-1/2 10 719215-3/8 2-1/8 5-1/2 10 719715-5/8 3-1/2 5-1/2 10 719815-5/8 3-1/2 5-1/2 10 73068-3/4 7 5-1/2 6 73078-3/4 7 5-1/2 6 73088-3/4 7 5-1/2 6 73098-3/4 7 5-1/2 6 *No Hanger Used - Attach with Lag ScrewsModel 4992 has the outlet in the bottom and issuppled with an 1-1/2 bottom spud.)

4 Unit will requirean external trapway suppled by others. Placementof waste line will be determined by the style of thetrapway to the Exclusions set forth below, CR/PLpromises to the consumer to repair, or at the optionof CR/PL, to replace any part of this plumbing productwhich proves to be defective in workmanship ormaterials under normal use for five years from thedate of purchase. All costs of removal, transportationand reinstallation to obtain warranty service shall bepaid by the consumer. During this five year period,CR/PL will provide, subject to the Exclusions sectionset forth below, all parts free of charge, necessaryto correct such defects if this plumbing product hasbeen installed and maintained in accordance withwritten INSTRUCTIONS furnished by CR/PL with thisplumbing : CR/PL PRODUCTS SHALL NOT BELIABLE FOR INCIDENTAL OR CONSEQUENTIALDAMAGES, INCLUDING COSTS OF INSTALLATIONOR WATER DAMAGE, OR FOR DAMAGESRESULTING FROM ABUSE OR MISUSE OR FROMFAILURE TO INSTALL OR MAINTAIN THISPLUMBING PRODUCT IN ACCORDANCE WITHTHE WRITTEN INSTRUCTIONS FURNISHED BYCR/PL PRODUCTS.

5 USE OF CLEANINGPRODUCTS CONTAINING CALCIUMHYPOCHLORITE (CHLORINE) SHALL CONSTITUTEIMPROPER MAINTENANCE. SOME STATES DONOT ALLOW THE EXCLUSION OR LIMITATION OFINCIDENTAL OR CONSEQUENTIAL DAMAGES, SOTHE ABOVE LIMITATION MAY NOT APPLY TO THECONSUMER. THE ONLY WARRANTY MADE BYCR/PL PRODUCTS IS SET FORTH ABOVE ANDALL IMPLIED WARRANTIES WHICH MIGHT ARISE,INCLUDING THE IMPLIED WARRANTIES OFMERCHANTABILITY OR FITNESS FOR APARTICULAR PURPOSE ARE Service: In order to obtain warrantyservice or adjustments, contact the builder, dealeror plumber from whom the product waspurchased, or the Customer Service Department,CR/PL Products, 201 East Fifth Street, Mansfield,OH 44901 (419/522-4211).

6 In obtaining warrantyservice, all transportation, shipping and freightcharges connected with transporting any part ofthis plumbing product must be prepaid by theconsumer. It is the responsibility of the consumerto establish the warranty period by verifying theoriginal purchase date. A bill of sale, cancelledcheck or some other appropriate payment recordmay be kept for this purpose. This warranty givesyou specific legal rights. You may also have otherrights which vary from state to Five Year Warranty4CR/PL 1235 Hartrey Avenue Evanston, IL. 60202 FORM NO: 2057 Rev: 5/22 IN flanged outlet connecton onto waste Detail - Outlet and tighten the water supply supply and waste connections for leaks.

7 CranePlumbing is not responsible for leaking or place the urinal on the hangers. Align thefixture outlet with the outlet fitting in the wall. Fixturemay be leveled or height adjusted by loosing hangerscrews and adjusting as Not overtighten the screws as this can crack fixture is virtually maintenance free. Clean it withany non-abrasive household cleaner and a soft striking it with metal objects, as they tend to marthe surface. These marks, or heavy soil, can be removedwith a soft cleaner meant for glazed the hangers in place and secure with to see that the hangers are level. and properlyspaced apart for the fixture you are 2 Hanger Detail7 HangersC-L ofSlot3/4 WallReinforcing2 Female OutletOutlet Connection24 Standard17 2 Connect flush valve to top inlet spud urinals are top inlet.

8 Use flush valves with vacuumbreaker, 1 angle screwdriver stop and flush ( gpf / lpf flush valves are:Sloan Royal Delany Flushboy Zurn Aquaflush # 186-1# F451-1# Z-60003-WS1 Urinals that have back inlets will require flush valvesspecifically designed for that purpose. Provide forconnections in the wall when using those urinals)