Instruction Manual - Hobbico

1 DYFZ5000 for DYFA0500 THROUGH THIS Manual BEFORE STARTING CONSTRUCTION. ITCONTAINS IMPORTANT instructions AND WARNINGS CONCERNING THEASSEMBLY AND USE OF THIS Contents Copyright 2003 Instruction ManualWARRANTYD ynaflite guarantees this kit to be free from defects in both material and workmanship at thedate of purchase. This warranty does not cover any component parts damaged by use ormodification. In no case shall Dynaflite s liability exceed the original cost of thepurchased kit. Further, Dynaflite reserves the right to change or modify this warranty withoutnotice. In that Dynaflite has no control over the final assembly or material used for finalassembly, no liability shall be assumed nor accepted for any damage resulting from the use bythe user of the final user-assembled product. By the act of using the user-assembled product,the user accepts all resulting liability.

2 If the buyer is not prepared to accept the liabilityassociated with the use of this product, the buyer is advised to return this kitimmediately in new and unused condition to the place of purchase. Box 788 Urbana, IL 61803(217) 117 in. [2972mm]Wing Area: 1050 sq in [ dm2]Weight:60 oz [1700 g]Wing Loading: oz/sq ft [ g/dm2]Length:49 in. [1245mm]Radio: 2-Channel with 2 servosIntroduction ..2 Safety Precautions ..2 Additional Items Required ..3 Flight Equipment ..3 Building Supplies ..4 Optional Supplies & Tools ..4 Important Building Replacement Parts ..5 Important Note About Contents ..6 Assembly ..7 Assemble the Wing ..7 Install the Tow Hook the Rudder ..9 Assemble the Horizontal the Elevator Linkage ..10 Install the Assembly ..12 Prepare the Model for Flying ..13 Set the Control Throws ..13 Balance the Model ( )..14 Balance the Model Laterally ..14 Identify Your Model ..14 Charge the Inspection.

3 15 Range Check ..15 AMA Safety a Safe Place to Fly ..16 Flying ..16 Thank you for purchasing the Dynaflite Bird ofTime ARF. The Bird of Time ARF is a lightweight,high performance model that has great soaringqualities. It is a classic model, a timeless designthat always draws a crowd of admirerswherever it is flown. With its strong fiberglassfuselage the Bird of Time ARF is easy toassemble and is very strong. We hope you willenjoy years of soaring your the latest technical updates or manualcorrections to the Bird of Time, visit the website listed below and select the Dynaflite Bird ofTime ARF. If there is new technical informationor changes to this model, a "tech notice" boxwill appear in the upper left corner of the Your Bird of Time ARF should not beconsidered a toy, but rather a sophisticated,working model that functions very much like afull-size airplane. Although the Bird of Time is alightweight soaring model, just the same as anyR/C plane, it should still be flown with while gliding at slow speeds, the Bird ofTime could possibly cause injury to yourself orspectators and damage You must assemble the Bird of Timeaccording to the instructions .

4 Do not alteror modify the model, as doing so may result inan unsafe or unflyable model. In a few cases theinstructions may differ slightly from the those instances the written instructionsshould be considered as You must take the time to build straight, trueand You must use an R/C radio system that is infirst-class You must correctly install all R/C and othercomponents so that the model operatescorrectly on the ground and in the You must check the operation of the modelbefore everyflight to insure that all equipmentis operating and that the model has remainedPROTECT YOUR MODEL,YOURSELF & THIS IMPORTANTSAFETY PRECAUTIONINTRODUCTIONTABLE OF CONTENTS2structurally sound. Be sure to check clevises orother connections often and replace them ifthey show signs of wear or If you are not already an experienced R/Cpilot, you should fly the model only with thehelp of a competent, experienced R/C : Take your time and follow theinstructions to end up with a well-builtmodel that is straight and you have not flown this type of model before,we recommend that you get the assistance ofan experienced pilot in your R/C club for yourfirst flights.

5 If you're not a member of an R/Cclub, your local hobby shop has informationabout clubs in your area whose membershipincludes experienced addition to joining an R/C club, we stronglyrecommend you join the AMA (Academy of ModelAeronautics). AMA membership is required to flyat AMA sanctioned clubs. There are over 2,500 AMA chartered clubs across the country. Amongother benefits, the AMA provides insurance to itsmembers who fly at sanctioned sites and , training programs and instructors areavailable at AMA club sites to help you get startedthe right way. Contact the AMA at the address ortoll-free phone number below:The Bird of Time ARF requires a two-channelradio with two servos and a receiver. Astandard receiver can be used, but you willneed one micro or mini servo and one standardservo. The mini/micro servo is needed for theflying stabilizer and is mounted in the rear ofthe fuselage, where it is very narrow.

6 If a miniservo is used you may need to trim the fuselageopening for the servo to the elevator is aerodynamicallycounter-balanced, a servo with at least 15 oz inof torque is :(HCAM0110) CS-12 mini, 35 oz in torque(FUTM0033) S3101 mini, oz in torque(HCAM0090) CS-5 micro, oz in torque(FUTM0041) S3106 micro, oz in torqueReceiver: While there is adequate room for afull size receiver, a small receiver, like thoselisted below, will be easier to install (low band:channels 11-35, high band: channels 36-60):(GPML0044) 4-channel FM, low band(GPML0045) 4-channel FM, high band(FUTL0442) 4-channel FM, low band(FUTL0443) 4-channel FM, high bandReceiver crystal:(FUTL62**) for GPM or FUT low band(FUTL63**) for GPM or FUT high bandAdditional items: 24" - 30" [610 - 765mm] Servo Extension Wire. High start (DYFP8301) or winch for launching. Receiver battery with sufficient capacity forextended soaring is required.

7 We recommend asquare battery with at least 500 mAh EquipmentADDITIONAL ITEMS REQUIREDA cademy of Model Aeronautics5151 East Memorial DriveMuncie, IN 47302(800) 435-9262 Fax (765) 741-0057 Internet address: , as the kit manufacturer, provide you with a topquality kit and instructions , but ultimately the qualityand flyability of your finished model depends onhow you build it; therefore, we cannot in any wayguarantee the performance of your completedmodel and no representations are expressed orimplied as to the performance or safety of yourcompleted addition to common household tools andhobby tools, here is the list of items used tobuild the Bird of Time ARF. Great Planes Pro CA and epoxy glue is recommended. 6-minute epoxy (GPMR6042) 1 oz. Medium CA (GPMR6008) Hobby knife (HCAR0105) #11 blades (5-pack, HCAR0211) Double-sided foam tape (GPMQ4440) formounting the receiver Sandpaper and sanding block Small Phillips screwdriver (#1) Drill Bits: 1/16" [ ], 5/64" [2mm], 3/32"[ ], 7/64" [ ], 1/8" [ ] CA applicator tips (HCAR3780) CA debonder (GPMR6039) Epoxy brushes (6, GPMR8060) Mixing cups (GPMR8056) 36" metal ruler (HCAR0475) Robart Super Stand II (ROBP1402) Hobbico Duster can of compressed air(HCAR5500) Rubbing alcohol (for epoxy clean up) Switch & Charge Jack Mounting Set(GPMM1000) Rotary tool such as Dremel Moto-Tool Servo horn drill (HCAR0698) Accu-Throw Deflection Gauge (GPMR2405) CG Machine (GPMR2400) Sealing Iron (TOPR2100) There are two types of screws used in this kit:Sheet metal screwsare designated by a numberand a length.

8 For example #6 x 3/4" [19mm]:This is a number six screw thatis 3/4" [19mm] screwsare designated by a number,threads per inch and a length. For example 4-40x 3/4" [19mm]:This is a number four screw that is 3/4"[19mm] long with forty threads per inch. When you see the term test fitin theinstructions, it means that you should firstposition the part on the assembly withoutusing any glue, then slightly modify or customfitthe part as necessary for the best fit. When you get to each step, read that stepcompletely through to the endbefore youbegin. Frequently there is important informationor a note at the end of the step that you need toknow before you start. Photosand sketches are placed beforethestep they refer to. Frequently you can studyphotos in following steps to get another view ofthe same parts. The Bird of Time ARF is factory-covered withTop Flite MonoKote film. Should repairs everbe required, MonoKote can be patched withadditional MonoKote purchased is packaged in six-foot rolls, butsome hobby shops also sell it by the foot.

9 Ifonly a small piece of MonoKote is needed for aminor patch, perhaps a fellow modeler wouldgive you some. MonoKote is applied with amodel airplane covering iron, but in anemergency a regular iron could be used. A rollof MonoKote includes full instructions forapplication. Following are the colors used onthis model and order numbers for six foot (TOPQ0204) Orange (TOPQ0202)IMPORTANT BUILDING NOTESO ptional Supplies and ToolsBuilding Supplies45 ORDERING REPLACEMENT PARTSTo order replacement parts for the Dynaflite Bird of Time ARF, use the order numbers in theReplacement Parts List that follows. Replacement parts are available only as listed. Not all parts areavailable separately. Replacement parts are not available from Product Support, but can be purchasedfrom hobby shops or mail order/Internet order firms. Hardware items (screws, nuts, bolts) are alsoavailable from these outlets.

10 If you need assistance locating a dealer to purchase parts, click on "Where to Buy". If this kit is missing parts, contact DynafliteProduct PARTS LISTO rder NumberDescriptionHow to PurchaseMissing piecesContact Product SupportInstruction manualContact Product SupportFull-size plansNot Kit with JoinersContact Your Surface SetSupplier to SheetIMPORTANT NOTES ABOUT WORKING WITH FIBERGLASS When you are cutting into fiberglass, be sure youare cutting the correct place. Unlike wood, you arenot able to go back and easily fix a mistake. Whenever you are gluing a part to the insideof fiberglass it is important to roughen theinside surface of the fiberglass with 80-gritsandpaper and then wipe the area withrubbing alcohol. The molding process leaves awaxy residue that can prevent a good bondbetween the glue and the parts being :The fuselage included in this kit ismade of fiberglass, the fibers of which maycause eye, skin and respiratory tract blow into a part to remove fiberglass dust,as the dust will blow back into your eyes.