KBS MORTAR SEAL - PFP Systems

1 Not classified as hazardous according to Worksafe Australia criteriaCompany: KBS Passive Fire Pty LtdAddress: PO Box 1502 Crows Nest NSW 1585 AustraliaTelephone: +61 2 9969 7100 Fax: +61 2 9969 7200 Product Name: KBS MORTAR SealCAS RN No(s): None UN Number: NoneDangerous Goods Class: NoneSubsidiary Risk: NoneHazchem Code: NonePoisons Schedule Number: NoneFire-rated penetration seals for grouped electrical cable and combustibleand non-combustible seals for grouped electrical cable and combustible andnon-combustible powder mixture with no odour. Solubility in water is approximatelyKBS MORTAR SEALChemWatch Material Safety Data SheetCHEMWATCH 15980 Date of Issue: Mon 25-Mar-2002 IDENTIFICATIONSTATEMENT OF HAZARDOUS NATURESUPPLIER USEPHYSICAL DESCRIPTION/PROPERTIES APPEARANCE26/3/02 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 1 of @ 20 deg.

2 Point (deg C): Not applicableMelting Point (deg C): Not availableVapour Pressure (kPa): Not applicableSpecific Gravity: Point (deg C): Not applicableLower Explosive Limit (%): Not applicableUpper Explosive Limit (%): Not applicableSolubility in Water (g/L): ImmiscibleNAME CAS RN % MORTAR dry blend consisting of 100inorganic cement binders fillers lightweight aggregates performance additives The material is moderately discomforting to the gastro-intestinal tract and may be harmful if an unlikely route of entry in commercial/industrial dust may produce eye discomfort and abrasive eye solid/dust is abrasive and may be discomforting to the skin and may cause skin dust may be discomforting and may be harmful to the upper respiratory tract and lungs from repeated exposures over long HEALTH HAZARDACUTE HEALTH EFFECTS SWALLOWED EYE SKIN INHALEDCHRONIC HEALTH EFFECTS26/3/02 3.

3 07 PMChemWatch MSDS for KBS MORTAR SEALPage 2 of 7 Principal routes of exposure are usually by skin contact / eye contact and inhalation of generated with any chemical product, contact with unprotected bare skin; inhalationof vapour, mist or dust in work place atmosphere; or ingestion in any form,should be avoided by observing good occupational work : DO NOT induce vomiting. If vomiting occurs, lean patient forward or place on left side (head-down position, if possible) to maintain open airway and prevent : Observe the patient : Never give liquid to a person showing signs of being sleepy or with reduced awareness; becoming : Give water (or milk) to rinse out mouth, then provide liquid slowly and as much as casualty can comfortably : Seek medical this product comes in contact with the eyes:1: Immediately hold the eyes open and wash with fresh running : Ensure complete irrigation of the eye by keeping eyelids apart and away from eye and moving the eyelids by occasionally lifting the upper and lower : If pain persists or recurs seek medical : Removal of contact lenses after an eye injury should only be undertaken by skilled product comes in contact with the skin:1: Immediately remove all contaminated clothing, including footwear (after rinsing with water).

4 2: Wash affected areas thoroughly with water (and soap if available).3: Seek medical attention in event of : If dust is inhaled, remove to fresh : Encourage patient to blow nose to ensure clear breathing : Rinse mouth with water. Consider drinking water to remove dust from : If irritation or discomfort persists seek medical : If fumes or combustion products are inhaled: Remove to fresh : Lay patient down. Keep warm and : Prostheses such as false teeth, which may block airway, should be removed, where possible, prior to initiating first aid procedures4: If breathing is shallow or has stopped, ensure clear airway and apply resuscitation, preferably with a demand valve resuscitator, bag-valve mask device, or pocket mask as trained. Perform CPR if AID SWALLOWED EYE SKIN INHALED26/3/02 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 3 of 75: Transport to hospital, or exhaust is adequate under normal operating exposure to workplace dust is not controlled, respiratory protectionis required; wear SAA approved dust respirator fit is essential to obtain adequate confined spaces where there is inadequate ventilation, wear full-faceair supplied breathing glasses with side shields; or as required, Chemical lenses pose a special hazard; soft lenses may absorb irritants andall lenses concentrate physical protective gloves, eg.

5 Safety : : Eyewash : Barrier : Skin cleansing Half-Face Full-Face Powered AirFactor Respirator Respirator Respirator------------------------------ ---------------------------------------- ------ADVICE TO DOCTOR PRECAUTIONS FOR USEEXPOSURE STANDARDSENGINEERING CONTROLSPERSONAL PROTECTION EYE HANDS/FEET OTHER RESPIRATOR26/3/02 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 4 of 7 10 x ES P1 - PAPR-P1 Air-line* - - 50 x ES Air-line** P2 PAPR-P2 100 x ES - P3 - Air-line* - 100+ x ES - Air-line** PAPR-P3* - Negative pressure demand ** - Continuous local concentration of material, quantity and conditions of use determinethe type of personal protective equipment required.

6 For further information,consult site specific CHEMWATCH data (if available), or your OccupationalHealth and Safety woven plastic or paper bag with sealed plastic linerNOTE: Bags should be stacked, blocked, interlocked, and limited in height so that they are stable and secure against sliding or that containers are clearly as recommended by away from strong contact with water or moisture until ready to : Store in original : Keep containers securely : Store in a cool, dry, well-ventilated : Store away from incompatible materials and foodstuff : Protect containers against physical damage and check regularly for : Observe manufacturer's storing and handling storage at temperatures higher than 40 deg. restrictions. SAFE HANDLINGSTORAGE AND TRANSPORT SUITABLE CONTAINER STORAGE INCOMPATIBILITY STORAGE REQUIREMENT TRANSPORTATIONSPILLS AND DISPOSAL MINOR SPILLS26/3/02 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 5 of 7 Clean up all spills dry clean up procedures and avoid generating protective clothing when risk of exposure up or sweep in suitable containers for : Clear area of personnel and move : Alert Fire Brigade and tell them location and nature of : Control personal contact by using protective equipment and dust : Prevent spillage from entering drains, sewers or water : Avoid generating : Sweep, shovel up.

7 Recover product wherever : Put residues in labelled plastic bags or other containers for : If contamination of drains or waterways occurs, advise emergency : Recycle wherever possible or consult manufacturer for recycling : Consult State Land Waste Management Authority for : Bury residue in an authorised : Recycle containers if possible, or dispose of in an authorised : Non : Not considered to be a significant fire : Expansion or decomposition on heating may lead to violent rupture of : Decomposes on heating and may produce toxic fumes of carbon monoxide (CO).5: May emit acrid POISONS INFORMATION CENTRE24 HOUR SERVICE :- 13 11 26 POLICE OR FIRE BRIGADE :- 000 (exchange):-1100 NEW ZEALAND POISONS INFORMATION CENTRE Dunedin :-(03)479 1200 (Normal Hours) :-(03)474 0999 (Emergency)End of Report MAJOR SPILLS DISPOSALFIRE/EXPLOSION HAZARD CONTACT POINTCONTACT26/3/02 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 6 of 7 Date of Preparation: Mon 25-Mar-2002 Print Date: Mon 25-Mar-2002 This document is copyright.

8 Apart from any fair dealing for the purposesof private study, research, review or criticism, as permitted under theCopyright Act, no part may be reproduced by any process without writtenpermission from CHEMWATCH. TEL (+61 3) 9572 4700 OTHER INFORMATIONE mail Address: 3:07 PMChemWatch MSDS for KBS MORTAR SEALPage 7 of 7