Example: air traffic controller
Overseas Business Department - yuken-usa.com
“Hydraulics”is one of drive systems to control machinery and equipment, comparable with pneumatics and electricity. It was in the early 1900’s that practical hydraulic applications were …
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Overseas Business Department - yuken-usa.com
yuken-usa.comBASIC HYDRAULICS AND COMPONENTS TABLE of CONTENTS ... remote control Accumulator, ... Water hydraulic crane, ...
Pressure Reducing Valves / Pressure Reducing and Check …
yuken-usa.comPressure reducing valves are used to set the pressure of a hydraulic circuit below that of the main circuit. In addition, operation under remote control is possible by using the remote control port.
Pilot Operated Check Valves - yuken-usa.com
yuken-usa.com508 Pilot Operated Check Valves Hydraulic Fluid: Viscosity 30 mm 2/s (141 SSU), Specific Gravity 0.850 Pressure Drop CPT-03, CPDT-03 CPG-03, CPDG-03 0 10 20 30 40 50 L/min 0 0.8 PSI 100 175 MPa Pressure Drop Δ P 50 0 0.4
3/8 Solenoid Operated Directional Valves, DSG-03 Series
yuken-usa.com363 DIRECTIONAL CONTROLS DSG-03 Series Solenoid Operated Directional Valves E DSG-03 Series Solenoid Operated Directional Valves 1. 2. 3. In case of the special two position valve, please refer to page 369 for details.
YUKEN Hydraulic Equipment
yuken-usa.comSolenoid Controlled Pilot Operated Directional Valves Pilot Operated Directional Valves Manually Operated Directional Valves 1 2 5 10 20 50 100 200 500 10002000 5000 L/min U.S.GPM.3 .5 1 2 10 50 100 200 500 10005 20
Related documents
CPX terminal - Festo
www.festo.comContents and general instructions II Festo P.BE−CPX−FB13−EN en 0811c PROFIBUS, PROFIBUS−DP® are registered trade marks of PROFIBUS International (P.I.) SIMATIC® is a registered trade mark of Siemens AG TORX® is a registered trade mark of Acument Intellectual Properties, LLC (Manufacturer: Acument Global Technologies
Safety control system standard EN ISO 13849-1 - SMC ETech
content2.smcetech.com3 Under EN ISO 13849-1, the consideration of safety starts with the risks associated with the machine, its function and its operation. Machine designers are obliged to eliminate risks before considering further measures to reduce or control risks (EN ISO 12100).