RAILING GUIDE - Trex

COMPOSITE DECKING – TREX SELECT

A. Wood-Plastic Composite Lumber; a. Material Description: Composite Decking consisting of recycled Linear Low Density Polyethylene (LLDPE) and recycled wood. The product is extruded into shapes and sizes as follows: i. Trex Select Decking Boards; 0.875” x …

  Composite, Select, Trex, Decking, Composite decking trex select

2020 DECKING INSTALLATION GUIDE - Trex

Issues with Concrete, Cement, Mortar, or Stucco Dust When working with cement, concrete, mortar, or stucco, protect the decking as much as possible in order to not get dust particles on the decking surface. These particles, once they get hot or wet, can cause a reaction on the decking surface and are very difficult to remove.

  Concrete

TREX DECKING

balcony or even a roof-top retreat, trex has you covered. rich textured finish hidden fasteners help keep the rich texture of trex completely pristine and unblemished by deck screws. learn more on page 11. quick cleaning forget sanding and staining. with just soap and water, you can keep your trex deck totally clean. boundless design possibilities

  Deck

COMPOSITE DECKING – TREX TRANSCEND AND TREX …

Modulus of Elasticity ASTM D4761 412,000psi 200,000 psi Modulus of Rupture ASTM D4761 3280 psi 500 psi * Ultimate strength values are not meant for design analysis. Design value are for tems peratures up to 130F (54C) 2.2 Accessories . A. Fasteners: a. Trex Universal Hideaway Hidden Fasteners

  Composite, Modulus, Rupture, Trex, Decking, Modulus of rupture, Transcend, Composite decking trex transcend and trex

TREX Fascia Installation Recommendations

Trex Fascia utilized around the perimeter of a deck must be gapped with the same requirements as Trex decking to allow for air flow and expansion/contraction of the fascia. When Using Approved Fascia Fasteners: NOTE: The fasteners listed below can only be used with 1x8 or 1x12 fascia product, and cannot be used with

  Perimeter

SECTION 1 - IDENTIFICATION - documents.trex.com

section 8 – exposure controls / personal protection : VENTILATION: Provide local exhaust ventilation and general room ventilation to maintain exposure concentrations of thermal decomposition products below the respective OSHA PEL’s.

  Identification, Section, Section 1

2019 INSTALLATION GUIDE - documents.trex.com

5 Trerx.comet1x-.8m1e SAFETY When working on any construction project, you should wear protective clothing and safety equipment. Wear safety glasses, gloves, a dust mask and long sleeves,

TREX TRANSCEND RAILING

self-tapping screws provided (use three outer holes; do not use hole in RSB that is closest to post). If two hole bracket is included, attach with two self-tapping screws (provided). Placing Baluster Spacers 9. Snap baluster spacer into bottom …

  Screw, Tapping, Tapping screws

Maximum Joist Spacing for Decks - CKCOG

Lag Screws or Bolts Joist Hanger Deck Joist 1-5/8” Min to 5” Max Existing Wall Sheathing Deck Joist Existing Floor Joist Ledger Board Hold-Down or Similar Tension Devise located in at least 2 locations, within 24” of each end of deck. Min of 1,500 lb stress design capacity for each device Existing Fully threaded 3/8” diameter lag screw.

  Deck, Maximum, Spacing, Joists, Maximum joist spacing for decks, Deck joist