SAFETY DATA SHEET - Pakmix

1 SAFETY data SHEETI ssuing Date 30-Apr-2015 Revision Date 30-Apr-2015 Revision Number 01. IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND THE COMPANY/UNDERTAKINGGHS product identifierProduct NamePortland Cement Based ProductsOther means of identificationSynonymsPakmix Concrete, Pakmix Fiber Reinforced Concrete, Pakmix Super 5000 Concrete Mix, Pakmix Type I/II Portland CementPakmix Fast Set Concrete, Pakmix Instant Post Set, Pakmix Sand Mix, Pakmix Crack Resistant Concrete, Pakmix Type N Masonry Cement Recommended use of the chemical and restrictions on useRecommended UseFootings, Slab, Posts, Block and Mortar RepairUses advised againstNo information availableSupplier's detailsEmergency telephone numberEmergency TelephoneNumber800-272-56492. HAZARDS IDENTIFICATIONC lassification This chemical is considered hazardous according to the OSHA Hazard Communication Standard 2012 (29 CFR )Acute Oral ToxicityCategory 4 Skin Corrosion/IrritationCategory 1 Serious Eye Damage/Eye IrritationCategory 1 CarcinogenicityCategory 1 ASpecific Target Organ Toxicity (Repeated Exposure)Category 2 GHS Label elements, including precautionary statementsEmergency OverviewSupplier AddressPakmixPO Box 1561 Middlesboro, KY 40965 TEL.

2 800-272-5649_____Signal WordPage 1 / 8 DangerHazard Statements Harmful if swallowed Causes severe skin burns and eye damage May cause cancer May cause damage to organs through prolonged or repeated exposurePakmix Surface Bonding Cement, Pakmix Glass Block Mortar, Pakmix Veneer Stone Mix, Pakmix Fast Setting Repair Mortar Pakmix Type S Masonry Cement, Pakmix Mortar Mix, Pakmix Type S Mortar Mix, Pakmix Vinyl Concrete, Pakmix Anchor CementPakmix Commercial Grade Grout, Pakmix Non-Shrink Grout, Pakmix Precision Non Shrink Grout, Pakmix Stop Leak, PM Fastset Acelerator_____WPS-PAK-001 - Portland Cement Based ProductsRevision Date 30-Apr-2015 Precautionary StatementsPrevention Wash face, hands and any exposed skin thoroughly after handling. Do not eat, drink or smoke when using this product. Obtain special instructions before use. Do not handle until all SAFETY precautions have been read and understood. Use personal protective equipment as required.

3 Wear eye/face protection. Do not breathe dust/fume/gas/mist/ Advice Immediately call a POISON CENTER or doctor/physician. Specific treatment (see supplemental first aid instructions on this label)Eyes IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continuerinsing. Immediately call a POISON CENTER or IF ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water/shower. Wash contaminated clothing before IF INHALED: Remove victim to fresh air and keep at rest in a position comfortable for IF SWALLOWED: Call a POISON CENTER or doctor/physician if you feel unwell. Rinse mouth. Do NOT induce Store locked Dispose of contents/container to an approved waste disposal Not Otherwise Classified (HNOC)Not applicableOther information 50% of the mixture consists of ingredient(s) of unknown COMPOSITION/INFORMATION ON INGREDIENTSS ynonymsPakmix Concrete, Pakmix Fiber Reinforced Concrete, Pakmix Super 5000 Concrete Mix, Pakmix Fast Set Concrete, Pakmix Instant Post Set, Pakmix Sand MixChemical NameCAS-NoWeight %Trade secretQuartz14808-60-740-70*_____Appeara nce GrayPage 2 / 8 Physical State Solid (powder).

4 Odor No information available_____WPS-PAK-001 - Portland Cement Based ProductsRevision Date 30-Apr-2015 Portland cement65997-15-110-30*Silica7631-86-95-1 5*Limestone1317-65-35*Gypsum (Ca(SO4).2H2O)13397-24-55*Aluminum oxide1344-28-15** Where range is displayed, the exact percentage (concentration) of composition has been withheld as a trade FIRST AID MEASURESD escription of necessary first-aid measures General AdviceImmediate medical attention is required. Show this SAFETY data SHEET to the doctor ContactRinse immediately with plenty of water, also under the eyelids, for at least 15 medical attention is ContactWash off immediately with soap and plenty of water removing all contaminated clothes andshoes. Immediate medical attention is to fresh air. If breathing is difficult, give oxygen. If symptoms persist, call a mouth. Drink plenty of water. Do NOT induce vomiting. Never give anything by mouthto an unconscious person.

5 If symptoms persist, call a of First-aidersUse personal protective equipment. Avoid contact with skin, eyes and important symptoms/effects, acute and delayedMost Important Symptoms/EffectsCorrosive Serious eye irritation or damage. Skin irritationIndication of immediate medical attention and special treatment needed, if necessaryNotes to PhysicianTreat FIRE-FIGHTING MEASURESS uitable Extinguishing MediaUse extinguishing measures that are appropriate to local circumstances and the surrounding Extinguishing MediaNo information Hazards Arising from the ChemicalAvoid dust DataSensitivity to Mechanical to Static Equipment and Precautions for FirefightersAs in any fire, wear self-contained breathing apparatus pressure-demand, MSHA/NIOSH (approved or equivalent) and fullprotective ACCIDENTAL RELEASE MEASURESP ersonal precautions, protective equipment and emergency procedures Personal PrecautionsAvoid contact with skin, eyes and clothing.

6 Use personal protective equipment. Avoid dustformation. Avoid inhalation of dust. Ensure adequate Precautions _____Environmental PrecautionsPage 3 / 8 See Section 12 for additional Ecological - Portland Cement Based ProductsRevision Date 30-Apr-2015 Methods and materials for containment and cleaning upMethods for ContainmentPrevent further leakage or spillage if safe to do for Cleaning UpAvoid dust formation. Clean up promptly by scoop or vacuum. Dispose of promptly. Cleancontaminated surface HANDLING AND STORAGEP recautions for safe handlingHandlingHandle in accordance with good industrial hygiene and SAFETY practice. Avoid dustformation. Do not breathe dust. Use only in area provided with appropriate exhaustventilation. In case of insufficient ventilation, wear suitable respiratory equipment. Avoidcontact with skin, eyes and clothing. Wear personal protective equipment. Do not eat, drinkor smoke during manufacturing use of this product.

7 Do not take internally. Wash thoroughlyafter handling. Remove and wash contaminated clothing before for safe storage, including any incompatibilitiesStorageKeep container tightly closed in a dry and well-ventilated ProductsStrong oxidizing agents. Acids. EXPOSURE CONTROLS / PERSONAL PROTECTIONC ontrol parametersExposure GuidelinesChemical NameACGIH TLVOSHA PELNIOSH IDLHQ uartz 14808-60-7 TWA: mg/m3 respirablefraction30/(%SiO2+2) mg/m3 TWA, TotalDust;250/%SiO2+5) mppcf TWA,respirable fraction; 10/(%SiO2+2)mg/m3 TWA, respirableTWA: mg/m3 (vacated)IDLH: 50 mg/m3 respirable dustTWA: mg/m3 respirable dustPortland cement 65997-15-1 TWA: 1 mg/m3 particulate mattercontaining no asbestos and <1%crystalline silica, respirablefractionTWA: 15 mg/m3 total dustTWA: 5 mg/m3 respirable fraction(vacated) TWA: 10 mg/m3 totaldust(vacated) TWA: 5 mg/m3respirable fractionTWA: 50 mppcf <1% CrystallinesilicaIDLH: 5000 mg/m3 TWA: 10 mg/m3 total dustTWA: 5 mg/m3 respirable dustSilica 7631-86-9-(vacated) TWA: 6 mg/m3 <1%Crystalline silicaTWA: 20 mppcf: (80)/(% SiO2) mg/m3 TWAIDLH: 3000 mg/m3 TWA: 6 mg/m3 Limestone 1317-65-3-TWA: 15 mg/m3 TWA: 5 mg/m3(vacated) TWA: 15 mg/m3(vacated) TWA: 5 mg/m3 TWA: 5 mg/m3 respirable dustTWA: 10 mg/m3 total dustGypsum (Ca(SO4).

8 2H2O) 13397-24-5 TWA: 10 mg/m3 inhalablefractionTWA: 15 mg/m3 total dustTWA: 5 mg/m3 respirable fraction(vacated) TWA: 15 mg/m3 totaldust(vacated) TWA: 5 mg/m3respirable fractionTWA: 10 mg/m3 total dustTWA: 5 mg/m3 respirable dustAluminum oxide 1344-28-1_____TWA: 1 mg/m3 respirable fractionTWA: 15 mg/m3 total dustTWA: 5 mg/m3 respirable fraction(vacated) TWA: 10 mg/m3 totaldust(vacated) TWA: 5 mg/m3respirable fractionPage 4 / 8-Appropriate engineering controls_____WPS-PAK-001 - Portland Cement Based ProductsRevision Date 30-Apr-2015 Engineering MeasuresShowersEyewash stationsVentilation systemsIndividual protection measures, such as personal protective equipmentEye/Face ProtectionTightly fitting SAFETY and Body ProtectionLightweight protective clothing. Protective ProtectionA system of local and/or general exhaust is recommended to keep employee exposures aslow as possible If exposure limits are exceeded or irritation is experienced, NIOSH/MSHA approved respiratory protection should be MeasuresProvide regular cleaning of equipment, work area and clothing.

9 Remove contaminatedclothing and protective equipment before entering eating or smoking PHYSICAL AND CHEMICAL PROPERTIESI nformation on basic physical and chemical propertiesFlammable PropertiesNot flammableExplosive PropertiesNo data availableOxidizing PropertiesNo data availableOther informationVOC Content (%)No data available10. STABILITY AND REACTIVITYR eactivityChemical stabilityStable under recommended storage of hazardous reactionsPhysical StateSolid (powder)AppearanceGrayOdorNo information availableOdor ThresholdNo information availableProperty Values Remarks/ - Method pH 13 None knownMelting Point/Range > C / >2700 FNone knownBoiling Point/Boiling Range> C / >2700 FNone knownFlash PointNo data availableNone knownEvaporation rateNo data availableNone knownFlammability (solid, gas)No data availableNone knownFlammability Limits in Airupper flammability limitNo data availablelower flammability limitNo data availableVapor PressureNo data availableNone knownVapor DensityNo data availableNone knownSpecific - knownWater SolubilitySlightly solubleNone knownSolubility in other solvents 0 knownPartition coefficient.

10 N-octanol/waterNo data availableNone knownAutoignition TemperatureNo data availableNone knownDecomposition TemperatureNo data availableNone known_____ViscosityNo data availablePage 5 / 8 None knownNo data - Portland Cement Based ProductsRevision Date 30-Apr-2015 None under normal PolymerizationHazardous polymerization does not to avoidDust formation. Incompatible materialsStrong oxidizing agents. Acids. decomposition productsSilicon oxides. Calcium oxides11. TOXICOLOGICAL INFORMATIONI nformation on likely routes of exposureProduct InformationInhalationInhalation of dust in high concentration may cause irritation of respiratory ContactCorrosive to the eyes and may cause severe damage including blindness. Causes seriouseye damage. Dust contact with the eyes can lead to mechanical ContactCorrosive. Dusts may cause mechanical irritation. May cause severe irritation and possiblyburns, especially in contact with broken if swallowed.