Example: air traffic controller
SAfETy INSTRUCTIONS WARNING CAUTION
installed jumper wire between the Float Switch terminals on the control and wire the float switch to the dehumidifier as shown in figure 10. Overflow safety switches on condensate pumps can be wired to the Float Switch terminals in a similar fashion . fIGURE 9 – level the Unit fIGURE 10 – float Switch Wiring 90-1885 90-1857 9
Tags:
Information
Domain:
Source:
Link to this page:
Related documents
The Ultimate Guide to Float Level Sensors
fpisensors.comThe Ultimate Guide to Float Level Sensors fpisensors.com 7 The float switch level sensor A float switch is one of the devices most commonly used to sense liquid level. Although float switches are available in many styles, sizes, materials and with many options, they typically consist of a float with an internal magnet that
CU 211 and CU 212 - Grundfos
net.grundfos.com5.1 Two float switches and parallel operation with three float switches Use CU 211 in systems with one pump and two float switches. The pump is controlled by the liquid level in the tank. – When the float switch, pos. 1, is lifted up by the liquid, the pump is started. – When the float switch, pos. 1, is no longer lifted up by the
Fluid level gauge Fluid level sensor Temperature switch ...
www.hydac.comthe tube. The float now shows the level of the fluid in the tank. If the level of the fluid drops again, the float will activate a switch contact. For the NO switch (type C) the circuit will then be closed, for the NC switch (type O) the circuit will be opened. The special dual switching model (type W) offers two possibilities. It can
INSTALLATION INSTRUCTIONS - Zoeller Pump Company
www.zoellerpumps.com2. The installation of automatic pumps with variable level float switches or nonautomatic pumps using auxiliary variable level float switches is the responsibility of the installing party and care should be taken that the tethered float switch will not hang up on the pump apparatus or pit peculiarities and is secured so that the pump will shut off.
Catalogue 2016 - VDO
www.vdo.net.auPressure Switches - Oil Light 56 Pressure Switches Heavy Duty 57 Temperature Switches 58 Temperature Senders & Switches 59 Temperature Senders Specification overview 60 Adaptors, brass 61 T-Piece Adaptors 61 Fuel Level Senders 62 Tank Unit Sender Accessories 62 Reed Switch Senders 62 Tubular Type Senders 63 RPM Senders 63
MPPT Solar Charge Controller Installation and Operation …
westech-pv.comBattery type Bulk charge stage Float charge stage Equalize charge stage Gel 14.2 13.7 14.4 AGM 14.3 13.7 14.5 Sealed 14.4 13.7 14.6 Flooded 14.6 13.5 14.8 User define 10-15V 10-15 10-15V Battery type-The most common battery type associated with the specified charging settings.
SYSTEM Guard - Zoeller Pump Company
www.zoellerpumps.com√ INCLUDED * VARIABLE LEVEL FLOAT SWITCH DUPLEX ALTERNATING PANEL: • 115V, single phase • NEMA 4X watertight enclosure w/ lockable latch • (2) 30 amp motor start relays • Pump HOA switches • Top-mounted red alarm beacon light • 81 - 84 decibel rated alarm horn • Horn silence and alarm test switches • Alarm automatically resets
25A In-vehicle 3-Stage 12V Battery Charger
www.redarc.com.auvoltage level for a predetermined period of time or until the current being drawn by the output drops to less than 4A for 30 seconds; after which the charger will enter Float stage. Float stage maintains 13.3V on the output battery, keeping the battery topped up. This counteracts the battery’s self discharging. When a load applied to the