Scaffolding Procedure - Westlake
Provide guidance for the proper selection and use of appropriate scaffolding equipment and personnel protective equipment to meet the requirements of this program. Ensure that all employees required to use scaffolding have received the appropriate level of training required by subpart L of 29 CFR1926.454.
Tags:
Use and, Scaffolding, Use scaffolding
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document:
Documents from same domain
EPOLENE® Polymers - Westlake Chemical
www.westlake.comTemporary protective coatings for metal surfaces. Scuff-resistant emulsion coatings for glass bottles. Flatting agents for lacquers and enamel paints.
PELS® ANHYDROUS CAUSTIC BEADS - westlake.com
www.westlake.comProduct Stewardship Summary PELS Anhydrous Caustic Beads Page 2 of 8 Edition 3 caustic soda solution with added surfactants stabilizes dissolved substances and prevents re-deposition. PELS caustic soda is also used, for example, to clean and prepare sheet steel in galvanizing plants, and caustic soda is the chief ingredient for …
Anhydrous, Caustic, Beads, Epls, 174 anhydrous caustic beads
Epolene Polymers - Westlake Chemical
www.westlake.comEpolene® Polymers Emulsifiable Waxes • Epolene E-10 An oxidized homopolymer developed for water-emulsion floor polishes, Epolene® E-10 imparts excellent slip resistance, outstanding toughness, and good durability to polish films.
Liquid Chlorine - Westlake Chemical
www.westlake.comLiquid Chlorine Property Specification Basis Test Method Purity Chromatograph 99.5 Vol. Min. Vol. % Gas Moisture 150 Wt. Max. PPM Process Analyzer
Injection Molding Troubleshooting Guide - Westlake Chemical
www.westlake.comInjection Molding Troubleshooting Guide Brittleness Contamination Bubbles (cont.) Source(s) Cause(s) Mold (cont.) Improper runners or gates Mold temperature too low Material Excessive moisture Operator Inconsistent cycle Machine Excessive injection speed or pressure Excessive back pressure
Westlake Polyethylene Brochure 2018
www.westlake.comLINEAR LOW DENSITY POLYETHYLENE (LLDPE) Westlake linear low density polyethylene (LLDPE) film resins meet the demanding needs of food packaging, consumer and industrial packaging, and …
LIQUID CAUSTIC SODA (Sodium Hydroxide) - westlake.com
www.westlake.comProduct Stewardship Summary Liquid Caustic Soda Page 3 of 10 Edition 1 Environmental Effects Caustic soda should be kept out of lakes, streams, ponds, or other water sources.
LIQUID CAUSTIC SODA (Sodium Hydroxide)
www.westlake.comLiquid Caustic Soda Page 4 of 10 Edition 1 caustic soda is shipped hot (50% solution at 100°-180°F and 73% solution at 225°-255°F), downstream customers should be careful when unloading and repackaging it. Liquid Caustic Soda becomes more viscous and harder to handle as it approaches its solidification point, at which it becomes solid.
Evaluation Phrases I. - Westlake
www.westlake.com• Is skilled in proposing optional solutions y • Exceeds normal output standards • Continuously produces more than expected • Is an important contributor to the successes of the department • Makes a substantial contribution to the continued operation and growth of the organization • Consistently exceeds performance goals
Related documents
OSHA Rules for ScaffoldingOSHA Rules for Scaffolding
www.a1scaffoldmfg.comDO NOT use scaffolding where the user can come into contact with live power lines. Inspect & Check Take no chances. Inspect the scaffold setup after erection and daily when in use. Don’t remove or allow removal of any parts without the OK from the Competent Person. When wire rope is used, inspect it on each job.
See SUPPORTED SCAFFOLDS - California Department of ...
www.dir.ca.govand train all involved in erection, use, and dismantling. Safe Work Practices Scaffolding accidents can occur during erection, use and dismantling of scaffolds. The following Safe Work Practices can help in preventing scaffold related accidents. Do these during scaffold design and selection: • Select proper scaffold/scaffolding material.
General Guide for Scaffolds and Scaffolding Work
www.safeworkaustralia.gov.ausafe erection, alteration, dismantling and use of scaffolds, and safe use, handling, storage and transport of scaffolding. The WHS Regulations include specific duties for a person conducting a business or undertaking with management or control of scaffolding plant, powered mobile plant and plant that lifts or suspends loads. Designers,
CIS56 - Safe erection, use and dismantling of falsework
www.hse.gov.ukspecifies the use of a particular method of work; contractors carrying out design work as part of their contribution to a project; and temporary works engineers, including those designing formwork, falsework, scaffolding and sheet piling. Designers have duties under the Construction (Design and Management) Regulations 1994 (CDM) and must:
Scaffolding Code of Practice 2021 - WorkSafe.qld.gov.au
www.worksafe.qld.gov.auScaffolding Code of Practice 2021 Page 8 of 77 It also includes ensuring, so far as is reasonably practicable the: • design, provision and maintenance of safe scaffolding plant and structures • safe erection, alteration, dismantling and use of scaffolding • safe use, handling, storage and transport of scaffolding plant.
Erection, Scaffolding, Of scaffolding, And use of scaffolding
Scaffolding - Department of Commerce
www.commerce.wa.gov.auPersons erecting the scaffold had no prior instruction or training in the erection of scaffolding. 4. Uncertificated persons carrying out this work must be directly supervised by a certificated scaffolder. 5. The scaffold was moved and then altered …
A Guide to Scaffold Use in the Construction Industry
www.osha.govScaffolds Use in the Construction Industry rule aims to protect workers using scaffolding in construction work. Scaffolding hazards continue to rank high on the list of the most frequently cited standards in the construction industry. Scaffold-related fatalities account for a significant number of fatalities in the
HEALTH AND SAFETY METHOD STATEMENT - S.A. …
sascaffoldinglimited.co.ukon the use of BS EN 12811-1 Guide to good practice for scaffolding with tubes and fittings. 30. Discussions will take place with the Principal Contractor in relation to rescue in the event of a scaffold operative falling with harness on. Normally rescue will be with the use of the forklift, MEWP, Mobile tower, Secure ladder etc. 31.