Schuberth Concept C2 b - Autocom

1 Helmet Fitting GuideSchuberth Concept C28 December 2004 Firstly, remove the horseshoeshaped padding on thebottom of the helmet by un-clipping the two the two T8 Torxscrews on the side of thehelmet as shown. These holdthe cheek pads to the helmetsouter the screws undone,gently separate the cheekpad away from the outershell, but do not remove fromthe helmet the cheek pad slightlyseparated away from theshell, you can now peel thetop of the lining away fromthe polystyrene to expose themoulded circular hole in a strip of loop velcroover the hole. Place thespeaker over the mouldedhole onto the velcro with thespeaker in a horizontalposition and the wire comingfrom the back of the the liner to itsoriginal microphone boom needsto placed up where the strapcomes through the cheek padleaving just a sufficientamount of microphone toreach the centre of the boom through thechin strap hole and the redconnector pulled all the waythrough, velcro the remainingpart of the boom to screwing the cheekpad back to the outer shellconnect the red and onewhite connector to the loom then gets wedgedbetween the cheek pad andthe outer shell.

2 Be careful notto position the loom too farup into the the same to the othercheek pad so you have bothspeakers inside the liner ofthe cheek pads. Carefully tidyup the longer wire remainingaround the back of thehelmet and then connect thelast white connector togetherso both speakers the connectors are allconnected together and thewires are tidily tucked away,put the horseshoe shapedpadding back on the base ofthe , make sure that youcan easily flip the black visorup and down, if not you mayhave to adjust the loom sothe visor works as off clip to expose twoscrews. Remove screws sowhen separating cheek padsyou can un-clip seal.