Seattle Department of Construction sdci and Inspections ...

1 Sdci 312. Tip Seattle Department of Construction and Inspections Seattle Permits part of a multi-departmental City of Seattle series on getting a permit Decks, Fences, and What information will I need to apply for a deck permit? Arbors for Single-Family For most decks, you will need: Homes in Seattle A site plan A scaled site plan that shows all structures on your Updated January 3, 2019 site, including the proposed deck. Your site plan dimensions must show that your deck meets our land use requirements for location and lot area cover- This Tip addresses the questions most commonly asked age. (See Tip 103, Site Plan Requirements). by homeowners wishing to construct decks, fences and An elevation drawing arbors.

2 This information applies to single-family homes A scaled elevation drawing that shows the height on single-family and lowrise multifamily zoned properties. of the proposed deck (height above existing or final grade, whichever is lower), including any guardrails Decks vary widely in the scope of their Construction ; and stairs. Your elevation drawings must offer side you will need to get a permit for some. You generally views of structures, from the ground to the top of the do not need a permit to build a fence, but you need to structure. (See Tip 303, Applicant Responsibilities follow our regulations. You generally need a permit to and Plan Requirements for Single Family and Two- build arbors.)

3 Unit Dwellings). Construction notes Decks Your notes on your drawings should call out the size What type of permit do I need to build deck? and type of posts proposed ( , pressure treated wood), the method of support for the posts ( , Most decks on single-family zoned properties only require poured concrete footings), joist size, span and spac- a subject-to-field-inspection (STFI) permit. We issue STFI ing, and the method of attaching the deck to the permits over the counter, usually on the day you apply. house ( , with a ledger board and joist hangers). You can apply at the SDCI Applicant Services Center (See Tip 303A, Common Seattle Residential Code (ASC), located on the 20th floor of Seattle Municipal Tow- Requirements).

4 Er, 700 Fifth Ave., (206) 684-8850. For more information about STFI permits, visit our website A field inspection application form sdci/permits/permits-we-issue-(a-z)/cons truction- You may fill this out at the ASC when you apply. You permit---subject-to-field-inspection. will need the assessor's parcel number and legal description for your property. You need a Construction permit to build a deck that is more than 18 inches above the ground or that is a roof Please note that homeowners may do their own deck (built on top of part of the building). ( Seattle Resi- drawings. A professional stamp is rarely required on dential Code Item 7). You may need a permit if these plans.

5 Your building site contains environmentally critical areas (ECAs). For more information about Construction permit What are the land use requirements for decks? requirements, visit our website permits/permits-we-issue-(a-z)/construct ion-per- Lot coverage mit---addition-or-alteration. If your deck is more than 36 inches above the ground, your deck counts toward the percentage of your property on which you can build (called lot coverage). For most single-family zoned lots, the total 700 5th Avenue, Suite 2000. Box 34019. Seattle , WA 98124-4019. (206) 684-8600. Printed on totally chlorine free paper made with 100% post-consumer fiber SDCI Tip #312 Decks, Fences and Arbors for Single Family Homes in Seattle page 2.

6 Coverage is limited to 35 percent of the lot (on lots required rear yard as long as the deck is no closer 5,000 square feet or larger) or 1,000 square feet plus than 12 feet to the rear property line, and the deck 15 percent of the lot area (on lots smaller than 5,000 cover is no taller than 12 feet above the existing or square feet). We do not limit the size of decks that finished grade, whichever is lower. are less than 36 inches above the ground, unless you plan to build a deck in or near an ECA. For more in- We generally prohibit roof decks on garages and formation on these exceptions, see the Seattle Land carports located in required yards. In locations where a roof deck is not allowed, there are exceptions that allow a safety guardrail only (without a roof deck).

7 Decks are permitted on garages that meet our stan- dards for terraced garages; see the Land Use Code section Roof decks on houses must meet the general location standards for houses; see Tip 220, Lot Coverage, Height and Yard Standards for Homes in Single Family Zones. You are allowed INTERIOR. to have an open railing four feet above the maximum LOT. allowed height for houses. Residential Small Lot Zones. If you are building a deck on a residential small lot, please come in to the ASC to discuss your project with our staff. Lowrise 1, 2 and 3 Zones. If you want to build a deck addition to a single-family residences in these multifamily zones, please discuss your project with ASC staff.

8 What are the main Building Code requirements for my deck? STREET Structural Your deck design must provide sufficient structural Figure 1. Typical Interior Single Family Lot in Seattle support and attachments to meet safety standards. The minimum live load design that we require is 60. pounds per square foot. You should talk to a permit Use Code for Single Family zones. specialist in the ASC if you have questions about our structural requirements. Location Single Family Zones. As shown in the illustration of a Ledger connection typical single-family interior lot in Seattle (see Figure If your deck is supported at the house by a ledger, 1), there are portions of your lot in the front, sides, the ledger must be connected to your house so that and back, known as yards, in which decks more it will not pull away during an earthquake.

9 See pages than 18 inches above grade are not allowed. Note 6 and 7 for pre-approved standards for connecting that this 18 limit is measured to existing or final ledger to your house (called a prescriptive connec- grade, whichever is lower. Generally, you cannot tion). You can also hire an engineer to design the build a deck taller than 18 inches in the front 20 feet ledger connection and the guardrail. of your lot, the side 5 feet, and the rear 25 feet (or Guardrail (guards). the rear 20 percent of the lot depth, whichever is We require guardrails if your deck is more than 30. less (The minimum required depth of a rear yard is inches above adjacent surfaces, such as the ground or 10 feet.))

10 Tip 220 explains yard limitations in single- a lower roof. Your guardrail must be at least 36 inches family zones in greater detail. Please discuss specific tall with rail openings that are no more than 4 inches. conditions, including corner and through lots, with See page 8 for pre-approved connection details. our staff in the ASC. Important exception to rear yard provisions: We have special requirements for glass guardrails. See Covered, attached decks may project into the Seattle Building Code sections and 2407. LEGAL DISCLAIMER: This Tip should not be used as a substitute for codes and regulations. The applicant is responsible for compliance with all code and rule requirements, whether or not described in this Tip.