Example: marketing
Shift Lever Spring Replacement - Steering Column Services
When the shift lever becomes loose, it may flop between the steering wheel and dash without any tension. Most likely the cause is a broken shift lever return spring. This spring is mounted in the shift bowl and forces the lever to both return when pulled by the driver and engage the respective detent positions when shifted into the respective gears
Tags:
Information
Domain:
Source:
Link to this page:
Documents from same domain
Jeep Ignition Switch & Lock Cylinder Replacement …
www.steeringcolumnservices.comJeep Ignition Switch & Lock Cylinder Replacement Instructions This design was used on many Chrysler, Dodge and Jeep vehicles from the mid 1980's through 1995.
Remove Ford Column
www.steeringcolumnservices.com889 Molinaro Ct, Ivins, UT 84738 Tel 435-319-6011 • Email sales@steeringcolumnservices.com 8. Remove three (or four) screws from lower steering column shroud and remove both shrouds from column.
Related documents
SHIFT INTERLOCK SYSTEM - Autoshop 101
www.autoshop101.comthe shift lever in Park When the brakes are applied with the transmission in Park, the No. 1 spring pushes the cable, lock pin and plunger out toward the brake pedal. With the plunger released, the shift lever can be moved from Park. When the shift lever is in positions other than Park with the brakes released, the brake pedal
Using The Allison World Transmission Shift Selector
www.rvtechstop.comthen shift hydraulically to a default gear in “Convertor Mode” and release the lock-up clutch. This protects the transmission and allows travel with a restricted gear range to obtain service. As expected, a sophisticated transmission needs an equally sophisticated shift selector. Allison supplies either a touch pad or lever-type shift ...
q SERVICE BULLETIN - National Highway Traffic Safety ...
static.nhtsa.gova) Replace the SELECT LEVER COMPLETE assembly (on Legacy and Outback models) or, b) Replace the Park-Range switch (PLATE-GUIDE B) following the Select Lever disassembly / assembly procedure in the applicable Service Manual. IMPORTANT TIP: After removing the shift knob there will be a white plastic rod / plunger
Service Bulletin Bulletin No.: 19-NA-206 Date: September, …
static.nhtsa.gov8. Start the vehicle and verify that the Shift to Park message is NOT displayed. 9. Reinstall the front floor console trim plate and any other console and/or trim panels removed. Refer to the appropriate replacement procedures in SI. 5386339 10. Reinstall the transmission control lever knob (3). Refer to Transmission Control Lever Knob ...
SHIFT SELECTOR - Weller Truck
assets.wellertruck.com1. Park the vehicle on a level surface, shift to N (Neutral) and apply the parking brake. 2. Using a pushbutton shift selector, simultaneously press the UP and DOWN arrows one time. Using a lever shift selector, press the DIAGNOSTICS button one time. 3. The fluid level reading may be delayed until the following conditions are met: – Engine is ...
SHIFT SELECTOR OPERATION AND CODE MANUAL How to …
cdn.mpparts.com1. Park the vehicle on a level surface, shift to N (Neutral) and apply the parking brake. 2. Using a pushbutton shift selector, simultaneously press the UP and DOWN arrow buttons. Using a lever shift selector, press the DISPLAy MODE/DIAgNOSTIC button one time. 3. The fluid level reading may be delayed until the following conditions are met:
Installation and Operation Manual for 4L60E ... - US Shift
www.usshift.comUS Shift Transmission Control System instruction and operation manual. www.USshift.com Baumann Electronic Controls, LLC. Phone: (864) 646-8920 Email: support@usshift.com Address: 207 Mistr Lane, Pickens, SC 29671 This work and the ideas and processes contained herein are the exclusive property of