SLOPE FACE STABILIZATION FOR CRITICAL SLOPE …

SLOPE FACE STABILIZATION FOR CRITICAL SLOPE SURFACES State of California Department of Transportation District 04 David W. Yam Department of Transportation 111 Grand Avenue / P.O. Box 23660 Oakland, California 94623-0660 (510) 286-5662

Tags:

  Surfaces, Critical, Faces, Stabilization, Slope, Slope face stabilization for critical slope, Slope face stabilization for critical slope surfaces

Information

Related documents

DESIGN GUIDE AL #1 BRIDGES FOR LIVESTOCK AND ... - USDA

efotg.sc.egov.usda.gov

wide bearing pad. The streamside face of the bearing pad must be located a minimum distance of a 1.5:1 (from top of pad to stream bottom) horizontal projection from the toe of streambank. This is a minimum projection. In areas where the stream bank slope is flatter than 1.5:1, increase the horizontal projection to that of the streambank slope.

  Faces, Slope

Triathlon Knee System Surgical Protocol - Stryker MedEd

www.strykermeded.com

holes on the face of the Femoral Sizer marked “EPI”. > Locate the fixation pegs of the appropriate size Express 4:1 Cutting Block into the pin holes created on the distal femur. Note: Check run-out of the anterior cut. If there is a pronounced positive step, consider selecting the next smaller size 4:1 Cutting Block if the anterior femur

  Faces

Related search queries