Transcription of SPEC DATA - Pro-Twist
1 SD00705-10-16 Installation Guidelines 0-2500rpm Screwgun with torque adjustment - Overdriving may result in fastener failure or stripout of the work surfaceThe fastener is fully seated when the head s bearing surface is flush with the fastener must penetrate beyond the metal a minimum of three threads to comply with the Value ChartsScrews driven into steel were driven with three exposed threads on the off side of the connection, then pulled out withtesting that all results were obtained in strict adherence to ASTM test protocol. These ultimate figures areoffered only as a guide and are not guaranteed in any way by PrimeSource Building Products. A 3:1 safety ratiois TRUSS HEAD SELF-DRILL SCREWP roduct Specifications42 (Pull) Lbs. 1 Screws Ultimate Connection Value ChartShear to Metal28544455092411003895547271050121682 99941096133213378111223149215451650 TorsionalStrengthHead.
2 033 .033 .033 .033 .033 .033 .033 .033 .110 MTD812 MTD834 MTD8100 MTD8114 MTD8158 MTD8178 MTD8200 MTD8212 MTD8300 MTD10341/23/411-1/41-5/81-7/822-1/233 #FinishBulk Drill CapacityZincZincZincZincZincZincZincZinc ZincZincThread24 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-11724 hr. min. B-117#2 Reduced PhillipsPTESR 1408 Pro-Twist drill screws meet or exceed ASTM C-954 and/or C-1513 2016 PrimeSource Building Products, PRIMESOURCE FASTENERS ARE MANUFACTURED IN AN ISO 9002 AND ISO 14001 CERTIFIED AND APPROVED FACTORYTO PRIMESOURCE PERFORMANCE SPECIFICATIONS AND PRINT old standard head design for the attachment ofmetal lath and steel framingSPEC data Submittal Sheet # 007
