Example: quiz answers

Typical 0-10V - Lutron Electronics

To QS Devices(Up to 30 PDUs)Emergency ContactClosure InputProgrammable ContactClosure InputLUTRONQSM2-4W-CDevice: XQuantum Sensor Module (QSM)434 MHz Wireless Sensor Module30' Radius Coverage Area MaxLRF2-DCRB-WH434 MHz WirelessDaylight "(Dia) x "(D)Max # per QSM*device is surface-mounted andbattery powered, does notrequire power feedLRF2-OCRB-P-WH434 MHz WirelessOccupancy/Vacancy "(Dia) x "(D)MRF2-XXXX-L-WG434 MHz Pico Wireless ControlShown with CW-1-WHClaro WallplatePico "(H) x "(W) x "(D)w/ "(H) x "(W) x "(D)*see specification sheet formounting instructionsUP TO 10 PER QSMUP TO 10 PER QSMUP TO 10 PER QSMQSWS2-XXXX-WHSeeTouch Device.

To QS Devices (Up to 30 PDUs) Emergency Contact Closure Input Programmable Contact Closure Input LUTRON QSM2-4W-C Device: X Quantum Sensor Module (QSM)

Tags:

  Electronic, Lutron electronics, Lutron, Typical, Typical 0 10v

Information

Domain:

Source:

Link to this page:

Please notify us if you found a problem with this document:

Other abuse

Transcription of Typical 0-10V - Lutron Electronics

1 To QS Devices(Up to 30 PDUs)Emergency ContactClosure InputProgrammable ContactClosure InputLUTRONQSM2-4W-CDevice: XQuantum Sensor Module (QSM)434 MHz Wireless Sensor Module30' Radius Coverage Area MaxLRF2-DCRB-WH434 MHz WirelessDaylight "(Dia) x "(D)Max # per QSM*device is surface-mounted andbattery powered, does notrequire power feedLRF2-OCRB-P-WH434 MHz WirelessOccupancy/Vacancy "(Dia) x "(D)MRF2-XXXX-L-WG434 MHz Pico Wireless ControlShown with CW-1-WHClaro WallplatePico "(H) x "(W) x "(D)w/ "(H) x "(W) x "(D)*see specification sheet formounting instructionsUP TO 10 PER QSMUP TO 10 PER QSMUP TO 10 PER QSMQSWS2-XXXX-WHSeeTouch Device.

2 X(1 Gang US Backbox by Others)LOS-XXX-XXXX-WHCeiling MountOccupancy "(Dia) x "(D)3 #22 AWG Solid3 #22 AWG SolidEC-DIR-WHDaylight " #22 AWG SolidEC-IR-WHFixture MountableIR Sensor(1 Max per Ballast/Module) " #22 AWG Solid(1) CC-XXX-WHEcosystem Wall Control(1) CW-1-WHClaro 1 Gang Wallplate(1 Gang US Backbox by Others)C-FLRC-WHPersonal TransmitterFunction: On/Off, Raise/Lower,& Favorite Level "(H) x "(W) x .55"(D)UP TO 4 WIRED INPUTS (OF ANY TYPE) PER QSMORLOS-XXX-XXXX-WHCeiling MountOccupancy "(Dia) x "(D)3 #22 AWG Solid4 #22 AWG SolidEC-DIR-WHDaylight Sensorw/ IR " #22 AWG SolidEC-IR-WHFixture MountableIR Sensor(1 Max per Ballast/Module) " TO 4 PER ESNUP TO 4 PER ESN3 #22 AWG Solid(1) CC-XXX-WHEcosystem Wall Control(1) CW-1-WHClaro 1 Gang Wallplate(1 Gang US Backbox by Others)C-FLRC-WHPersonal TransmitterFunction: On/Off, Raise/Lower,& Favorite Level "(H) x "(W) x.

3 55"(D)UP TO 4 PER ESNORUP TO 4 PER ESNWIRING NOTES:EcoSystem Bus: Lutron cable C-CBL-216-GR-1 (2 #16 ConductorNon-Plenum) or C-PCBL-216-CL-1 (2 #16 ConductorPlenum rated).Otherwise use 2 #16 AWG by or better cable for dedicated Lutron networkterminated with RJ45 connectors (to be provided byothers). 328 feet (100m) maximum #12 AWG ( mm )2 #12 AWG ( mm )QS Link Wiring as Required by Control Link Length(see chart below):Control Link LengthWire GaugeAvailable from Lutron inone cable:Less than 500ft (153m)Power (terminals 1&2):1 pair 18 AWG ( )GRX-CBL-346 SorGRX-PCBL-346 SData (terminals 3&4):1 pair 22 AWG ( ),twisted and shielded*500ft (153m) to 2000ft(610m)**Power (terminals 1&2):1 pair 12 AWG ( )GRX-CBL-46 LData (terminals 3&4):1 pair 22 AWG ( ),twisted and shielded**Alternate data-only cable: Use approved data link cable (22 AWG[ ] twisted/shielded) from Belden (model # 9461).

4 **Total length of the QS link must NOT exceed 2000ft (610m).QS Link can have a maximum of 99 devices, 100 zones, and 512switch communication link uses NECl Class 2/PELV wiring. Follow alllocal and national electrical codes when installing NEC Class 2/PELV wiring with line voltage QS DEVICES EITHER PROVIDE OR CONSUME POWER DRAW UNITS(PDUs). SEE PRODUCT SPECIFICATION SHEETS TO ENSURE APPROPRIATEPOWER HAS BEEN PROVIDED FOR EQUIPMENT Input Feed120V/277V Input Feed120V/277V Input Feed120V/277V Input Feed120V/277 VPower for ESNQSE-CI-AP-DEnergi Savr NodeProgramming "(H) x "(W) x "(D)(1) NT-PJ8X2-WHDouble Category 5e Data Jack8-Conductor, RJ45(1 Gang US Backbox by Others)Wireless RouterApple iPod Touchor iPhone MobileDigital DeviceDedicated EthernetConnection(Minimum of (1) Per Project)QSN-4T16-SEnergi Savr Node QS (ESN)with (4) Switched Outputs,(4) 0-10V Channels, and(1) QS Communication "(H) x "(W) x "(D)

5 ZONE#40-10V CHANNEL#4/120V/277 VSWITCHED OUTPUT#4 ZONE#30-10V CHANNEL#3/120V/277 VSWITCHED OUTPUT#3 ZONE#20-10V CHANNEL#2/120V/277 VSWITCHED OUTPUT#2 ZONE#10-10V CHANNEL#1/120V/277 VSWITCHED OUTPUT#1IF 0-10V CONTROL SIGNALIS NOT REQUIRED FOR A ZONE,REMOVE THE 0-10V WIRING ICON ANDONLY SHOW 2 #12 AWG ( ).EQUIPMENT REQUIRED FOR ESN PROGRAMMING ONLYC-ESN-SETUPL utron Electronics Co., Inc. 7200 Suter Road | Coopersburg, PA 18036 | USA(610) 282-3800 | fax: (610) 282-1146 CONCEPT DRAWINGNOT FOR CONSTRUCTIONAll dimming ballasts to be LutronEcoSystem, Hi-Lumeor Eco-10 to confirm all to verify quantity, location &finish of all faceplates, dimmers, switches,receptacles &cable/phone jacks to be LutronNOVA T*.

6 Lutron Field Service commissioningincluded in all systemsinitiates an 8 year limited electrical contractor must contactLutron (800-523-9466) to set upvisit with 10days Number:Drawn By:Drawing Revision:Drawing Date:Sheet:1 OF #CPM/ALF1##### Typical 0-10 VESN ConceptDrawing


Related search queries