Transcription of WHEN AUDIBLE DEVICES ARE SOUNDING
1 MS-9200 UDLS/E Fire Alarm Control Panel Operating Instructions NORMAL - Only the GREEN POWER LED is on. PANEL KEY - The key to open the panel can be found at the All other LED's are off. LCD display will read SYSTEM ALL following location: NORMAL. when AUDIBLE DEVICES ARE SOUNDING - FOR AN ALARM. 1. Evacuate the protected area 2. Notify the monitoring service and/or the Fire Department immediately. Tell them briefly what happened and what your current status is. Phones: _____ _____. Fire Department Monitoring Service 3. If the Fire Department is responding, be prepared to provide directions to arriving firefighters. FOR TROUBLE ONLY. 1. Notify the monitoring service and/or Fire department if this panel is connected to either one, and tell them what is happening.
2 2. Silence AUDIBLE DEVICES by unlocking and opening the panel and pressing the ACKNOWLEDGE/STEP key. The yellow system TROUBLE LED will remain on. Contact authorized service personnel immediately! (See Below). WARNING! DO NOT ALLOW TROUBLE CONDITIONS TO REMAIN LOGGED IN THE SYSTEM. THE PROTECTION THE SYSTEM OFFERS HAS BEEN COMPROMISED, OR ELIMINATED when A. TROUBLE CONDITION EXISTS. To return to normal after an alarm Manual activation (Fire Drill or otherwise). 1. Do not enter the protected area until safe to do so. Notification Appliance Circuits (NACs) can be activated by 2. Clear all initiating DEVICES . Smoke detectors will not reset pressing and holding the DRILL key for at least two seconds. if there is still smoke in the area.
3 NOTE: You may want to disconnect municipal box by sliding 3. Reset the control panel (PRESS the RESET key) DISCONNECT switch, located on 4 XTMF module, to its disconnect position (to the right). If a DACT is con- Power failure or brownout nected, notify the monitoring service before conducting If AC power drops too low or fails, the AC POWER LED will go out, any fire drills or tests. the system TROUBLE LED will turn on, and the panel buzzer and any other AUDIBLE trouble DEVICES will sound. Contact authorized Alarm Silencing service personnel immediately. See below. Notification Appliance Circuits may be silenced by pressing the ALARM SILENCE key. The ALARM SILENCED LED will turn on. Subsequent alarms will reactivate circuits.
4 Press the RESET key to clear the "silenced" condition. NOTE: Notification Appliance Circuits may be programmed as nonsilenceable. Also, Signal Silence Inhibit, if enabled, will prevent silencing of NACs for one minute after an alarm (see manual). In the event of trouble, contact the To test the lamps, LCD display and piezo sounder local Fire-Lite Service Representative Press and release the RESET key and check all LED's. Every LED. should be on, LCD shows all pixels on, piezo sounder beeps. Name: _____ For more information, refer to the MS-9200 UDLS/E Manual, Document #52750. It is kept in the following location: Company: _____. Address: _____. THIS SHEET SHALL BE FRAMED ADJACENT TO. Telephone Number: _____ THE CONTROL PANEL.
5 Document #52773 Rev. A 11/04/05 ECN 05-680.
