XL-UH242 Operation Manual

1 Thank you for purchasing this SHARP product. To obtain the best performance from this product, please read thismanual carefully. It will guide you in operating your SHARP COMPONENT SYSTEMXL- uh242 Micro Component system consisting of XL-UH242 (main unit)and CP- uh242 (speaker system ).AccessoriesPlease confirm that the following accessories are MANUALXL- uh242 Note:Only the above accessories are control 1(RRMCGA081 AWSA)AM loop antenna 1(QANTL0010 AWZZ)FM antenna 1(92 LFANT1535A)Note:This product is not compatible with MTP and AAC file InstructionSPECIAL NOTESCAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,DO NOT REMOVE COVER (OR BACK).NO USER-SERVICEABLE PARTS INSIDE. REFER SERVIC-ING TO QUALIFIED SERVICE of Graphical Symbols:The lightning flash with arrowhead symbol,within an equilateral triangle, is intended toalert the user to the presence of uninsulated dangerous voltage within the product s en-closure that may be of sufficient magnitudeto constitute a risk of electric shock to exclamation point within an equilateraltriangle is intended to alert the user to thepresence of important operating and main-tenance (servicing) instructions in the lit-erature accompanying the : TO REDUCE THE RISK OF FIRE OR ELECTRICSHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN - use of controls or adjustments or performanceof procedures other than those specified herein may re-sult in hazardous radiation to CATV system installer.

2 This reminder is provided to call the CATV system installer's attention to Article 820-40 of the National Electrical Code that provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as OF CONFORMITYSHARP MICRO COMPONENT system , MODEL XL-UH242 This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired PARTY: SHARP ELECTRONICS CORPORATION Sharp Plaza, Mahwah, New Jersey 07430-2135 TEL : 1-800-BE-SHARPFor Business Customers : URL equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules.

3 Theselimits are designed to provide reasonable protection against harmful in-terference in a residential installation. This equipment generates, uses,and can radiate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to ra-dio communications. However, there is no guarantee that interferencewill not occur in a particular installation. If this equipment does causeharmful interference to radio or television reception, which can be deter-mined by turning the equipment off and on, the user is encouraged to tryto correct the interference by one or more of the following measures:Reorient or relocate the receiving the separation between the equipment and the equipment into an outlet on a circuit different from that towhich the receiver is the dealer or an experienced radio/TV technician for Regulations state that any unauthorized changes or modificationsto this equipment not expressly approved by the manufacturer could voidthe user's authority to operate this :Licensed under one or more of Pat.

4 4,972,484, 5,214,678,5,323,396, 5,530,655, 5,539,829, 5,544,247, 5,606,618, 5,610,985,5,740,317, 5,777,992, 5,878,080 or 5,960, YOUR RECORDSFor your assistance in reporting this unit in case of loss or theft, please record below the model number and serial number which are located on the rear of the unit. Please retain this of of 03/12/17XL- uh242 3 XL-UH242 Important Instruction IMPORTANT SAFETY INSTRUCTIONS1 Read Instructions - All the safety and operating instructions shouldbe read before the product is Instructions - The safety and operating instructions should beretained for future Warnings - All warnings on the product and in the operatinginstructions should be adhered Instructions - All operating and use instructions should - Unplug this product from the wall outlet before not use liquid cleaners or aerosol cleaners. Use a damp cloth - Do not use attachments not recommended by the prod-uct manufacturer as they may cause and Moisture - Do not use this product near water - for ex-ample, near a bath tub, wash bowl, kitchen sink, or laundry tub; in awet basement; or near a swimming pool; and the - Do not place this product on an unstable cart, stand,tripod, bracket, or table.

5 The product may fall, causing serious injury toa child or adult, and serious damage to the product. Use only with acart, stand, tripod, bracket, or table recommended by the manufac-turer, or sold with the product. Any mounting of the product shouldfollow the manufacturer s instructions, and should use a mounting ac-cessory recommended by the product and cart combination should be moved withcare. Quick stops, excessive force, and uneven surfacesmay cause the product and cart combination to - Slots and openings in the cabinet are provided for venti-lation and to ensure reliable Operation of the product and to protect itfrom overheating, and these openings must not be blocked or cov-ered. The openings should never be blocked by placing the product ona bed, sofa, rug, or other similar surface. This product should not beplaced in a built-in installation such as a bookcase or rack unless properventilation is provided or the manufacturer s instructions have beenadhered Sources - This product should be operated only from the typeof power source indicated on the marking label.

6 If you are not sure ofthe type of power supply to your home, consult your product dealer orlocal power company. For products intended to operate from batterypower, or other sources, refer to the operating or Polarization - This product may be equipped with apolarized alternating-current line plug (a plug having one blade widerthan the other). This plug will fit into the power outlet only one is a safety feature. If you are unable to insert the plug fully into theoutlet, try reversing the plug. If the plug should still fail to fit, contactyour electrician to replace your obsolete outlet. Do not defeat the safetypurpose of the polarized Warnings - This product is equipped with a three-wiregrounding-type plug, a plug having a third (grounding) pin. This plugwill only fit into a grounding-type power outlet. This is a safety you are unable to insert the plug into the outlet, contact your electri-cian to replace your obsolete outlet.

7 Do not defeat the safety purposeof the grounding-type Protection - Power-supply cords should be routed sothat they are not likely to be walked on or pinched by items placedupon or against Attachment Plug - The product is equipped with an at-tachment plug having overload protection. This is a safety feature. SeeInstruction Manual for replacement or resetting of protective device. Ifreplacement of the plug is required, be sure the service technician hasused a replacement plug specified by the manufacturer that has thesame overload protection as the original plug. 03/12/17XL- uh242 4 XL-UH242 Important Instruction IMPORTANT SAFETY INSTRUCTIONS (continued)15 Outdoor Antenna Grounding - If an outside antenna or cable systemis connected to the product, be sure the antenna or cable system isgrounded so as to provide some protection against voltage surges andbuilt-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of themast and supporting structure, grounding of the lead-in wire to an an-tenna discharge unit, size of grounding conductors, location of antennadischarge unit, connection to grounding electrodes, and requirementsfor the grounding - For added protection for this product during a lightningstorm, or when it is left unattended and unused for long periods oftime, unplug it from the wall outlet and disconnect the antenna or cablesystem.

8 This will prevent damage to the product due to lightning andpower-line Lines - An outside antenna system should not be located in thevicinity of overhead power lines or other electric light or power circuits,or where it can fall into such power lines or circuits. When installing anoutside antenna system , extreme care should be taken to keep fromtouching such power lines or circuits as contact with them might - Do not overload wall outlets, extension cords, or integralconvenience receptacles as this can result in a risk of fire or electric and Liquid Entry - Never push objects of any kind into thisproduct through openings as they may touch dangerous voltage pointsor short-out parts that could result in a fire or electric shock. Never spillliquid of any kind on the - Do not attempt to service this product yourself as openingor removing covers may expose you to dangerous voltage or otherhazards. Refer all servicing to qualified service Requiring Service - Unplug this product from the wall outletand refer servicing to qualified service personnel under the followingconditions:a)When the power-supply cord or plug is damaged,b)If liquid has been spilled, or objects have fallen into the product,c)If the product has been exposed to rain or water,d)If the product does not operate normally by following the operatinginstructions.

9 Adjus t only those controls that are covered by the op-erating instructions as an improper adjustment of other controls mayresult in damage and will often require extensive work by a qualifiedtechnician to restore the product to its normal Operation ,e)If the product has been dropped or damaged in any way, andf)When the product exhibits a distinct change in performance - thisindicates a need for Parts - When replacement parts are required, be surethe service technician has used replacement parts specified by themanufacturer or have the same characteristics as the original substitutions may result in fire, electric shock, or Check - Upon completion of any service or repairs to this prod-uct, ask the service technician to perform safety checks to determinethat the product is in proper operating or Ceiling Mounting - The product should be mounted to a wallor ceiling only as recommended by the - The product should be situated away from heat sources suchas radiators, heat registers, stoves, or other products (including ampli-ANTENNA LEAD IN WIREPOWER SERVICE GROUNDING ELECTRODE system (NEC ART 250, PART H) GROUNDING CONDUCTORS (NEC SECTION 810-21)

10 GROUND CLAMPSNEC - NATIONAL ELECTRICAL CODES2898 AELECTRIC SERV ICE EQUIPMENTGROUND CLAMPE xample of antenna grounding as per National Electrical Code, ANSI/NFPA 70 ANTENNA DISCHARGE UNIT(NEC SECTION 810-20)fiers) that produce 03/12/17XL- uh242 5 XL-UH242 Important Instruction Special Note Supply of this product does not convey a license nor imply any rightto distribute content created with this product in revenue-generatingbroadcast systems (terrestrial, satellite, cable and/or other distribu-tion channels), revenue-generating streaming applications (via Inter-net, intranets and/or other networks), other revenu-generatingcontent distribution systems (pay-audio or audio-on-demand appli-cations and the like) or on revenue-generating physical media (com-pact discs, digital versatile discs, semiconductor chips, hard drives,memory cards and the like). An independent license for such use isrequired. For details, please visit Layer-3 audio coding technology licensed from FraunhoferIIS and Thomson.