Parallel Converters
Found 7 free book(s)An introduction to LLC resonant half-bridge converter
www.st.comcapacitor, with the load connected in parallel to one L, generates the LLC inverter. As previously stated, for any resonant inverter there is one associated DC-DC resonant converter, obtained by rectification and filtering of the inverter output. Predictably, the above-mentioned class of inverters will originate the "class D resonant converters".
Designing DC/DC converters based on SEPIC topology
www.ti.comnected in parallel with L1b, so the voltage across L1b is –V IN. The currents flowing through various cir-cuit components are shown in Figure 4. When Q1 is on, energy is being stored in L1a from the input and in L1b from C P. When Q1 turns off, L1a’s current continues to flow through C P and D1, and into COUT and the load. Both COUT and C
Ethernet Reference Manual, ENET-RM002D-EN-P
literature.rockwellautomation.comEtherNet/IP Parallel Redundancy Protocol Application Technique, ENET-AT006 Describes Parallel Redundancy Protocol (PRP) topologies, configuration considerations, and diagnostic methods. EtherNet/IP Device Level Ring Application Technique, publication ENET-AT007 Describes Device Level Ring (DLR) topologies, configuration considerations, and
CCG Series Datasheet - TDK
product.tdk.com13.2 to 30W DC-DC Converters CCG15-30W Series 1 Features Benefits The 1” x 1” footprint CCG15 and CCG30 series of isolated DC-DC converters operate from wide range 9 to 36Vdc or 18 to 76V inputs with 15W and 30W power levels and output voltages from 3.3V to 30V (1). Single output models can be adjusted -10% to +10% by using the trim terminal.
1719 Ex I/O - Rockwell Automation
literature.rockwellautomation.comI/P converters, or local indicators. The intrinsically safe signals are galvanically isolated from the bus and the power supply. •4-channel • Inputs Ex ia, Outputs Ex ia • Installation in Zone 2 or Class I, Div. 2, or safe area • Analog input, analog output • …
Appendix I Synthesizable and Non-Synthesizable Verilog ...
link.springer.comCode converters, 49 Coding guidelines, 79 Combinational logic, 10, 27 Combinational loop, 245 Combinational path, 286 Combinational path group, 284 Combinational shifters, 192 Comparators, 46 Compile, 267 Compile-characterize, 302 Compiler, 314 Computational blocks, 386 Concentration and replication, 18 Concurrent, 10 Concurrent execution, 161
DS STM32F42x 43x step2 - STMicroelectronics
www.st.com• 2×12-bit D/A converters • General-purpose DMA: 16-stream DMA controller with FIFOs and burst support • Up to 17 timers: up to twelve 16-bit and two 32-bit timers up to 180 MHz, each with up to 4 IC/OC/PWM or pulse counter and quadrature (incremental) encoder input • Debug mode – SWD & JTAG interfaces – Cortex-M4 Trace Macrocell™