CHAPTER 2 LIGHTING DESIGN STANDARDS AND …

← Back to document page

CHAPTER 2 LIGHTING DESIGN STANDARDS AND GUIDELINES SECTION 1: INTRODUCTION AND STANDARDS ........................................ .......... 1 VIRGINIA S LIGHTING LAW (SENATE BILL SB379 & SB1351) ................................. 1 ACKNOWLEDGMENTS ........................................ ........................................ ...... 2 LIGHTING ANALYSIS METHODS ........................................ .............................. 2 LIGHTING LEVELS ........................................ ........................................ ............. 2 LAMP AND LUMINAIRE DEPRECIATION FACTORS ....................................... 2 VDOT LIGHTING STANDARDS ........................................ .................................. 3 VDOT LIGHTING POLE FOUNDATIONS ........................................ ................... 4 VDOT ELECTRICAL SERVICE ........................................ ................................... 5 CONDUIT.

VDOT Traffic Engineering Design Standards and Guidelines Chapter 2 – Roadway Lighting 4 Pole Standard LP-3 Used for High Mast Luminaires. High mast lighting implies an area type of lighting with 3 to 12, 250-watt, 400-watt, 750-watt, or 1000-watt HPS luminaires mounted on poles or towers, at heights varying from approximately 60 feet to 150 feet.

  Design, Standards, Chapter, Lighting, Chapter 2, Chapter 2 lighting design standards and