Isolation Fault Troubleshooting - Application Note
Isolation Fault Troubleshooting - Application NoteVersion HistoryVersion - August 2022 - 1000V testing supported on S-Series optimizersVersion - October 2021 - Updated tester-to-module connection schemeVersion - October 2021 - 'Checking the DC Voltage' procedure updated, error codes updatedContentsIntroduction1Identifying an Isolation Fault1Troubleshooting an Isolation Fault (Using the Inverter LCD Display or SetApp)2Using an Insulation Tester7IntroductionIn photovoltaic systems with a transformer-less inverter, the DC is isolated from ground. Modules with defective module Isolation , unshielded wires, defective power optimizers, or an inverter internal Fault can cause DC current leakage to ground (PE - protective earth). Such a Fault is also called an Isolation Fault . This document describes how to identify and locate an Isolation Fault in a SolarEdge !
The Inverter Diagnostics Screen in the LCD Display or the Status Screen in SetApp. NOTE If using the LCD Display, this method is available from DSP1 firmware version 1.13.181 in three-phase inverters, and 1.210.693 in single phase inverters. The version can be checked from the ID status screen of the LCD. If required,
Download Isolation Fault Troubleshooting - Application Note
Information
Domain:
Source:
Link to this page:
Please notify us if you found a problem with this document: