Lab: Basic Static Route Configuration

← Back to document page

All contents are Copyright 1992 2007 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information. Page 1 of 20 Lab: Basic Static Route Configuration Topology Diagram Addressing Table Device Interface IP Address Subnet Mask Default Gateway R1 Fa0/0 N/A S0/0/0 N/A R2 Fa0/0 N/A S0/0/0 N/A S0/0/1 N/A R3 FA0/0 N/A S0/0/1 N/A PC1 NIC PC2 NIC PC3 NIC Learning Objectives Upon completion of this lab, you will be able to: Cable a network according to the Topology Diagram. Erase the startup Configuration and reload a router to the default state. Perform Basic Configuration tasks on a router.

Add exec-timeout 0 0 to console and virtual terminal lines on all routers. R1(config)#line console 0 R1(config-line)#exec-timeout 0 0 R1(config-line)#line vty 0 4 R1(config-line)#exec-timeout 0 0 Task 3: Interpreting Debug Output. Note: If you already configured IP addressing on R1, please remove all interface commands now before proceeding.

  Configuration, Basics, Route, Static, Command, Exec, Basic static route configuration