NAT Virtual Interface - community.cisco.com

← Back to document page

Corporate Headquarters: cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USACopyright 2005 cisco Systems, Inc. All rights Virtual InterfaceThe NAT Virtual Interface (NVI) feature removes the requirement to configure an Interface as either Network Address Translation (NAT) inside or NAT outside. An Interface can be configured to use NAT or not use allows traffic between overlapped VPN routing /forwarding (VRFs) in the same Provider Edge (PE) router, and traffic from inside to inside between overlapping for the NAT Virtual Interface FeatureFinding Support Information for Platforms and cisco IOS Software ImagesUse cisco Feature Navigator to find information about platform support and cisco IOS software image support. Access cisco Feature Navigator at You must have an account on If you do not have an account or have forgotten your username or password, click Cancel at the login dialog box and follow the instructions that appear.

NVI allows traffic between overlapped VPN routing/forw arding (VRFs) in the same Provider Edge (PE) ... ip nat pool 9 Cisco IOS Release 12.3(14)T ip nat pool To define a pool of IP addresses for Network Address Translation (NAT), use the ip nat pool command in global configuration mode.

  Cisco, Routing, Cisco ios