Replacing and Setting - Eaton

← Back to document page

InstallationInformationEaton CorporationHydraulics Operations15151 Hwy. 5Eden Prairie, MN 55344Telephone 612/937-7254Fax 612/937-7130Eaton DivisionGlenrothes, FifeScotland, KY7 4NWTelephone +44(0)1592-771-771Fax +44(0)1592-773-184No. 0 4-1 132October, 1999Copyright Eaton Corporation, 1999All Rights ReservedPrinted in USAReplacing and Setting1)Move up locknut, washer and o-ring onto speed sensor to allowfull exposure of sensor threads as posible. See Figure 12)Align a piston with the center of the sensor port. See Sensor PortView Figure )By hand, ligthly thread speed sensor body into the housing untilthe sensor touches against the motor piston. Do not force thesensor against the piston, damage may occur. See Figure the sensor has contacted the piston before the washertouches the )Position sensor by turning it out (CCW) until sensor alignmentnotchs are at a right angle 3 to motor centerline and then backout sensor one full turn or 360 . Retain sensor at this positionand torque locknut to 8,5-14,1 N m [75-125 lbf in].

Installation Information Eaton Corporation Hydraulics Operations 15151 Hwy. 5 Eden Prairie, MN 55344 Telephone 612/937-7254 Fax 612/937-7130 Eaton Ltd.

  Eaton, Replacing