Boot Loader
Found 8 free book(s)Assigning the Switch IP Address and Default Gateway - Cisco
www.cisco.comThe boot loader provides access to the flash file syst em before the operating system is loaded. Normally, the boot loader is used only to load, uncompress, and launch the operating system. After the boot loader gives the operating system control of the CPU, the boot loader is not active until the next system reset or power-on.
Catalyst 2960 Switch Boot Loader Commands - Cisco
www.cisco.comWhen you set boot loader boot command options, they are executed immediately and apply only to the current boot loader session. These settings are not saved for the next boot operation. Filenames and directory names are case sensitive. Examples This example shows how to boot the switch using the new-image.bin image:
xv6 - DRAFT as of September 4, 2018
pdos.csail.mit.eduContents 0 Operating system interfaces 7 1 Operating system organization 17 2 Page tables 29 3 Traps, interrupts, and drivers 39 4 Locking 51 5 Scheduling 61 6 File system 75 7 Summary 93 A PC hardware 95 B The boot loader 99 Index 105 DRAFT as of September 4, 2018 3 https://pdos.csail.mit.edu/6.828/xv6
AVR106: C Functions for Reading and Writing to Flash Memory
ww1.microchip.comDevices that support the read-while-write feature allows the boot loader code to be executed while writing. In such devices, the write functions will not return until the write has completed. 1.3. Addressing The Flash memory in AVR is divided into 16-bit words. This means that each Flash address location can store two bytes of data.
Product Information Flash Bootloader
cdn.vector.comthe Boot Manager component that performs sanity checks and starting of the according boot target. In addition of the static source code of the Flash Bootloader, the bus -specific configuration, the secu rity configuration and the flash memory configuration are generated by the configuration tool.
AN3155 Application note - STMicroelectronics
www.st.comOnce the system memory boot mode is entered and the STM32 microcontroller (based on Arm ®(a) cores) has been configured (for more details refer to AN2606) the bootloader code begins to scan the USARTx_RX line pin, waiting to receive the 0x7F data frame: a start bit, 0x7F data bits, even parity bit and a stop bit.
no longer recognized on PC (i.e. in the event of firmware ...
ts.thrustmaster.comENGLISH: Bootloader method: How to wake your HOTAS Warthog if it is no longer recognized on PC (i.e. in the event of firmware loss). Required system: PC running Windows® 10, 8.1 or 7.
ATmega48/V/88/V/168/V - Microchip Technology
ww1.microchip.com– Optional boot code section with independent lock bits In-system programming by on-chip boot program True read-while-write operation – Programming lock for software security •QTouch® library support – Capacitive touch buttons, sliders and wheels – QTouch and QMatrix acquisition – Up to 64 sense channels • Peripheral features