Search results with tag "Boot loader"
UG266: Silicon Labs Gecko Bootloader User’s Guide for GSDK ...
www.silabs.comThe Silicon Labs Gecko Bootloader is a common bootloader for all the newer MCUs and wireless MCUs from Silicon Labs. The Gecko Bootloader can be configured to perform a variety of functions, from device initialization to firmware upgrades. Key features of the boot-loader are:
Catalyst 2960 Switch Boot Loader Commands - Cisco
www.cisco.comWhen you set boot loader boot command options, they are executed immediately and apply only to the current boot loader session. These settings are not saved for the next boot operation. Filenames and directory names are case sensitive. Examples This example shows how to boot the switch using the new-image.bin image:
Assigning the Switch IP Address and Default Gateway - Cisco
www.cisco.comThe boot loader provides access to the flash file syst em before the operating system is loaded. Normally, the boot loader is used only to load, uncompress, and launch the operating system. After the boot loader gives the operating system control of the CPU, the boot loader is not active until the next system reset or power-on.
AVR106: C Functions for Reading and Writing to Flash Memory
ww1.microchip.comDevices that support the read-while-write feature allows the boot loader code to be executed while writing. In such devices, the write functions will not return until the write has completed. 1.3. Addressing The Flash memory in AVR is divided into 16-bit words. This means that each Flash address location can store two bytes of data.
xv6 - DRAFT as of September 4, 2018
pdos.csail.mit.eduContents 0 Operating system interfaces 7 1 Operating system organization 17 2 Page tables 29 3 Traps, interrupts, and drivers 39 4 Locking 51 5 Scheduling 61 6 File system 75 7 Summary 93 A PC hardware 95 B The boot loader 99 Index 105 DRAFT as of September 4, 2018 3 https://pdos.csail.mit.edu/6.828/xv6
Bootloader Design for Microcontrollers in Embedded Systems
www.beningo.comBootloader Design for MCUs in Embedded Systems Rev June 26, 2015 A2 ... During the initial stages of product development it is very common for the boot-loader to be ... programmer have to dig into flash programming but there is also a need to do a deep dive into memory maps, re-locatable vector tables, copy down functions, flash partitioning ...